real living BANCROFT GBO24-019-1 User manual

BANCROFT 5PC ALL WEATHER WICKER SET
2 CHAIRS
ASSEMBLY INSTRUCTIONS
ITEM# : GBO24-019-1 / GBO24-019-1NAVY
SKU# : 810669628 / 810680149
Need help? We are here for you! 1-888-733-8169 Toll Free
Or email us at customerserv[email protected],customerserv[email protected]
[email protected]

GENERAL BEST PRACTICES FOR ASSEMBLY:
● Read all instructions before starting
● Clear a flat covered space to begin assembly
● Always best to do it with a friend
● Note that hardware required is provided for every step
● Pay attention to orientation
● Number of the hardware corresponds to its letter in the package
● Helpful hints provided along the way
WARNINGS:
● Use the correct screws as indicated. All screws should be hand tightened until the complete piece is
assembled ( This will make the assembly process much easier ). Once the piece is fully assembled, then go
back and tighten all screws with provided tool.
● Keep all children and pets away from assembly area. Children and pets should be supervised when they are in the area of the
product construction.
● Keep assembly area at least 6 feet from any obstruction such as a fence, garage, house, overhanging branches, laundry line or
electrical wires.
● Some parts may contain sharp edges. When assembling and using this product, basic safety precautions should always be
followed to reduce the risk of personal injury and damage to the product. Please read all instructions before assembly and use.
● The chairs are not to be used for standing purposes and will not function as a stool or step-ladder. Use on even surfaces only.
● The chair is used at weight of 250lb (113.6kg). Improper use of this product or failure to use as directed
may result in injury. Not intended for commercial use.
MAINTENANCE ：
● STAIN RESISTANT CUSHIONS CARE —— KEEP THE CUSHIONS IN STORAGE ON RAINY DAYS.
● SPILLS: Immediately wipe up the spill using a white damp cloth. Repeat process if necessary until stain is gone.
Allow cushions to air dry.
● FABRIC CARE: Hand wash cold, non-chlorine bleach when needed, lay flat to dry. Cool iron if necessary. Do not
dry clean.
● ALL WEATHER WICKER PRODUCT CARE
● Before using, clean the product completely with a soft dry towel. When not in use, wipe free of any dirt or loose
objects, wash with a mild solution of soap and water, rinse thoroughly and dry completely. Do not use strong
detergent or abrasive cleaners. Screws can loosen over a period of usage, please check the screws occasionally
and re-tighten if necessary.

PARTS LIST FOR 1 CHAIR
A1
A2
B
1PC Left Arm 1PC Right Arm 1PC Chair back
C
H
I
1PC Seat Panel 1PC Seat Cushion 1PC Back Cushion
HARDWARE LIST FOR 1 CHAIR
D
E
F
10PC Washer 4PC Screw(M6x20mm) 6PC Screw(M6x35mm)
G
1PC Allen Wrench
Warranty
One year limited warranty.
Proof of purchase (dated register receipt) is required for warranty claims.
It remains the customer's responsibility for freight and packing charges to and from the service center.

STEP 1
Secure chair back (B) to left arm (A1) and right
arm (A2) with 4 washers (D) and 4 screws (E) by
using allen wrench (G). Do not fully tighten all the
screws now.
STEP 2
Secure seat panel (C) to assembled chair arms
(A1. A2) with 4 washers (D) and 4 screws (F) by
using allen wrech (G). Do not fully tighten all the
screws now.
B
G
E
A1
A1
A2
A2
D
E
D
C
D
F
G
G

STEP 3
Secure seat panel (C) to assembled chair back (B)
with 2 washers (D) and 2 screws (F) by using allen
wrench (G). Verify the alignment and adjust, then
fully tighten all the screws.
STEP 5
Put seat cushion (H) and back cushion (I) on the
chair. The chair is assembled.
B
C
H
I
D
F
G