Renfert Waxlectric light I User manual

© Renfert GmbH TM 04/02
Index
Waxlectric I and Waxlectric II
No. 2136 and No. 2137
Areas of Caution
• Before switching on check that the unit's voltage matches the main power supply.
• Units with faulty leads or other defects should not be used.
• Do not cover the power units when in use.
• Unroll connecting cable of the power supply, in order to avoid an overheating in case of short circuit.
• The tips of the waxing-up instrument reach a working temperature of 160oC.
> Danger of burning in case of improper use.
• The waxing-up instrument is only to be used for sculpturing waxes.
> Using other material can be dangerous for the user.
• Noxious fumes, smoke and hot splashes can occur at the working place.
> Protective clothing and ventilation/aspiration during work are unavoidable.
Cleaning / Maintenance
Clean the unit from time to time with a soft cloth. Do not wash the unit! Rub the tips clean after use.This
will prevent the wax burning into the tips and ensures the tips maintain their optimum heat conductivity.

© Renfert GmbH TM 04/02
Index
Fault Cause Remedy
Memory • Unit is not switched • Switch on and off via
setting does off via control panel. the control panel and
not work. not via the mains supply.
• Memory element defect. • Repair.
No display, • Interruption of power • Check power supply
nothing supply. and re-establish if
works. necessary.
• Fuse in main panel • Replace.
blown.
• Power adaptor defect. • Spare parts list.
• Power supply too low. • Use appropriate power
adaptor.
• Short-circuit in the tip. • Clean tip and handle;
• Exchange tip;
• Connection cable da-
maged - exchange
cable.
Unit func- • Tip not screwed in • Screw on the tip
tions, but no properly. sturdily.
heat in the • Contact between • Clean contact;
tips. handle and tip is dirty. • Exchange O-ring.
• Tip is defective. • Exchange tip.
• Handle cable is not • Plug in cable into socket
properly secured in until it clicks into place.
socket.
Troubleshooting Guide
Should your Waxlectric not function correctly, please proceed as follows:
Technical Specifications
Max. power requirement: 5 W (Waxlectric I)
10 W (Waxlectric II)
Min. working temperature: approx. 50oC
Max. working temperature: 160°C
Power supply: 12 VDC unregulated
Check polarity!
Power supply transformer: according to data transformer