Replas LYREBIRD User manual

ASSEMBLYINSTRUCTIONS
IMPORTANT:Pleasereadcarefullybeforeassembling.
LYREBIRD
SETTING
1.1m
InGround
TABLE:
1.Placetabletopfacedownonaflatsurface.
2.PlaceTablesupportsintoposition.
3.Attachtablesupportstothe40x200mmplanksusingthe100mmhexscrews,takingcarenottoovertightenasthis
couldstripthethread.
NOTE:Donottightenscrewsuntilallareinposition.

BENCHES:
1.Placebenchslatsfacedownonaflatsurface.
2.Attachbenchsupportstothe40x90mmslatsusingthe65mmhexscrews,takingcarenottoovertightenasthiscould
stripthethread.
NOTE:Donottightenscrewsuntilallareinposition.

Installation
Oncethesettinghasbeenisassembled,drillordigholesasperinstallationdiagram.

Placethesupportsoftheassembledsettingintotheholes.Positionthesettingandensurethatitiswellbracedtoprevent
movementandsagging.Atthisstageitisimportanttouseaspiritleveltocheckthatthetopishorizontalandthesupportsare
vertical.

Oncesatisfiedthatthesettingispositionedcorrectly,filltheholeswithconcrete,makingsureitispackedfirmlyaroundthe
supports.

Oncetheconcretehasset,removethebracing.

SUGGESTION:
WheninstallingIn‐Groundfurnitureitisagoodideatonailsometimberbracingacrossthebackofallsupports.Thiswillen‐
sureallsupportsarekeptparallelandinalignment,aswellaspreventinganysaggingoftheseatduring
installation.Donotremovebracinguntilafterconcretehasset.
TABLE:

1XTableTop‐pre‐assembled
2XTableSupports
16X14gx100mmHexHeadscrews
COMPONENTSLIST
BENCHES:

2XBenchTops‐pre‐assembled
4XBenchSupports
20X14gx65mmHexHeadScrews
Ifyourequirefurtherinstallationassistance,pleasecontactyoursupplier.

LBS-1100IG
685 685
LYREBIRD
IN GROUND
SETTING