Replas Premier Bench User manual

Premier Bench
1.8 m Free Standing, 3 Supports
www.replas.com.au
IMPORTANT:
Please read carefully before assembling.
Assembly Instructions:
2. Using the 65 mm hex head screws supplied, screw
the support onto the slats, taking care not to over
tighten as this could strip the thread in the support.
.
3. Once all the screws have been tightened turn over the
bench and place it into position.
Components List:
If you require further installation assistance, please contact your supplier.
1 x Bench Top  preassembled
2 X Bench Supports
12 X 14g x 75mm Hex Head Screws
1. Place bench slats face down on a flat surface.
1 x Bench Top  preassembled
2 X Bench Supports
12 X 14g x 75mm Hex Head Screws
4 Slats
1. Place bench slats face down on a flat surface.
2. Place supports inside metal frame.
3. Using a 3.5mm drill bit, drill into support through the pilot holes in the metal frame.
4. Using the 40mm hex head screws supplied, screw support onto frame, taking care not to
over tighten as this could strip the thread in the support.
5. Once all screws have been tightened turn bench over and place into position.

Premier Bench
1.8 m In Ground, 3 Supports
www.replas.com.au
IMPORTANT:
Please read carefully before assembling.
Assembly Instructions:
.
Components List:
If you require further installation assistance, please contact your supplier.
1 x Bench Top  preassembled
2 X Bench Supports
12 X 12g x 40 mm Hex Head Screws
1 x Bench Top  preassembled
2 X Bench Supports
12 X 12g x 40 mm Hex Head Screws
3 Slats 4 Slats
1. Place bench slats face down on a flat surface.
2. Using the 65 mm hex head screws supplied, screw
the support onto the frame.
3. Once all screws have been tightened turn bench
over and place into position.
Premier Bench
1.8 m In Ground, 2 Supports
www.replas.com.au
.
If you require further installation assistance, please contact your supplier.
Handy Hint
When installing an inground bench, it is a good idea to nail a timber plank to the sides of the supports,
approx 300mm from the underside of the horizontal slats. This will ensure that the supports are vertical and
parallel. This will also help to eliminate any sagging of the bench slats due to uneven ground or variation of hole
depths
.
Place the supports of the assembled bench (with the timber bracing still attached) into the holes and
pack the concrete mix around the bottom of each support. At this stage it is important to use a spirit level to
check that the seat is horizontal and the supports are vertical.
Once satisfied that the bench is positioned correctly, fill the holes with concrete, making sure it is packed
firmly around the supports. Once the concrete has set, remove the timber bracing.
1 x Bench Top pre-assembled
3 X Bench Supports
15 X 14 g x 65 mm Hex Head Screws