Replas Premier 3S FS 1800 User manual

ASSEMBLYINSTRUCTIONS
IMPORTANT:Pleasereadcarefullybeforeassembling.
PREMIER
3SupportSETTING
1.8m
FreeStanding
TABLE:
1.PlaceTabletopfacedownonaflatsurface.

2.Placesupportsintoposition.Ensurethattheoutsidetablesupportshavethecountersinkholesfacing
outwardsonthesupportupright.

3.Usingthe75mmbuglescrewssupplied,insertcrossarmthroughthecentretablesupportandscrewtothetwo
outsidetablesupports.

4.Securetablesupportstothe40x200mmplanksusingthe65mmhexscrews.
NOTE:Donotfullytightenscrewsuntilallareinposition.

5.Oncesupportsareinpositiontightenallscrews,takingcarenottoovertightenasthiscouldstripthethreadin
thetabletop.Then,usinga4.5mmdrillbit,drillapilotholeintocentrelegandsecureintocrossarmusing
75mmbuglescrew.
NOTE:Ensurethatalllegsaresquarebeforedrillingpilothole.

BENCHES:
1.Placebenchslatsfacedownonaflatsurface.

2.Usingthe65mmHexscrewssupplied,partscrew(acoupleofturnsonly)eachbenchsupporttotheslats.
NOTE:Donotfullytightenscrewsuntilallareinposition.

3.Oncesupportsareinpositiontightenallscrews,takingcarenottoovertightenasthiscouldstripthethreadin
thesupport.Onceallscrewshavebeentightened,turnsettingoverandplaceintoposition.
TABLE:

1XTableTop‐pre‐assembled
3XTableSupports
1XTableCrossarm—1380mm
30X14gx65mmHexHeadscrews
5X14gx75mmBugleScrews
COMPONENTSLIST
BENCHES:

2XBenchTops‐pre‐assembled
6XBenchSupports
30X14gx65mmHexHeadScrews

Ifyourequirefurtherinstallationassistance,pleasecontactyoursupplier.

815
1800
1800
440
310
4 x (40x200x1800)
Recycled Plastic Slats
3 x (40x90x1800)
Recycled Plastic Slats
40 x 90 x 1380 Cross Arm
Top of table
Concrete Slab
300
710 710
670
670
740
SIDE VIEW - Table only
PRS3-1800 FS
PREMIER 3-Support
FREE STANDING
SETTING
©
SIDE VIEW - Bench only