ROSE DISPLAYS ADVANCETRAK WITH METAL CLIP AND V CLIP User manual

Parts
35 Congress Street, Salem, MA 01970
Tel# [phone] Fax# [phone]
e-mail:[e-mail]
Note: Each graphic should already have
predrilled holes for snap rivets.
Step 1
Insert snap rivets into each predrilled hole.
Snap together. Fig. 1.
Step 2
Slide graphic into aluminum rails (top and
bottom). Rails will conceal snap rivets.
Fig. 2.
Step 3
Insert metal clips into channel of top
aluminum rail. Fig. 3. Slide into place.
Step 4
Insert V clip through hole in metal clips.
Fig. 4. Hang V clip from ceiling grid.
Note: Repeat steps 1-4 for each of your
graphics. Be sure to hang graphics close
enough together so they can be joined.
Step 5
Insert end caps onto rails. Fig. 5.
Note: If you are using multiple panels,
do not insert end caps. Jump to Step 6
on next page.
AdvanceTrak™
Instructions for assembly
Incept-4.8.03
The AdvanceTrak™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #03INSAdvanceTrak
Instruction Sheet
Aluminum Rail V clipMetal Clip
Figure 5
Figure 3 Figure 4
Figure 2Figure 1
End CapSnap Rivets
12AR300
Page 1 of 2

Parts
35 Congress Street, Salem, MA 01970
Tel# [phone] Fax# [phone]
e-mail:[e-mail]
Step 6
On one panel, insert one joiner bar into
top channel of top aluminum rail and one
joiner bar into bottom channel of bottom
aluminum rail.
Slide joiner bar into corresponding
channels of connecting rails on second
panel. Fig. 6. Slide rails together. Fig. 7.
Repeat Step 6 for additional panels.
Note: Apply tape to the back of graphic
panels to secure seam.
Step 7
Insert end caps onto rails. Fig. 8.
Instructions for connecting multiple panels
Incept-4.8.03
The AdvanceTrak™ is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #03INSAdvanceTrak
Figure 6 Figure 7
Figure 8
Aluminum Rail Joiner Bar End Cap
AdvanceTrak™
Instruction Sheet
12AR300
Page 2 of 2