Royalcraft Almeria Rattan Corner Sofa Set User manual

Almeria Rattan Corner Sofa Set
Assembly Instructions
ProducedinChinaforAMir&Co.,Ltd.
© A Mir & Co., Ltd. 1 / 11

www.ro
y
alcraft.co.uk
Product size:
Coffee Table: L80*W45*H38 cm
2-Seater Sofa: W110*D70*H75 cm
3-Seater Sofa: W165*D70*H75 cm
This product is for Domestic use only!
IMPORTANT, RETAIN FOR FUTURE REFERENCE
READ CAREFULLY

Almeria Rattan Corner Sofa Set
Assembly Instructions
ProducedinChinaforAMir&Co.,Ltd.
© A Mir & Co., Ltd. 2 / 11

www.ro
y
alcraft.co.uk
Before you start
Warnings
IMPORTANT, RETAIN FOR FUTURE REFERENCE
READ CAREFULLY
See enclosed instructions for assembly, safety and care
information.
Failure to follow the warnings could result in serious injury.
Handle heavy parts with care.
Ensure that this product is fully assembled as illustrated before
use.
This product should only be used on firm, level ground.
Keep small parts out of reach of children.
Do not stand or climb onto this product.
This product is intended for domestic use only.
Furniture can be dangerous if incorrectly used. No liability will be
accepted for damage or injury caused by incorrect use of this
product.
Dos
When you are ready to start, make sure that you have the right
tools, plenty of space and a clean, dry area for assembly.
Remove all packaging and banding and place the components
carefully on suitable surfaces to prevent damaging or scratching
them.
Check the pack and make sure you have all of the parts listed.
Check all screws and bolts are tightened and inspect regularly.
This product is suitable for all year outdoor use, but we
recommend that a furniture cover be used to add additional
protection to your product when not in use.
PLEASE NOTE - All cushions should be stored indoors after use.
The cushions are not waterproof.
During severe weather conditions and in the winter months we
recommend moving your furniture inside into a cool, dry place.
Before storage, ensure that the product is clean and dry.
To clean, wipe down with a sponge and warm soapy water and
wipe with a clean, dry cloth.
Cushions should be cleaned following the care instruction on the
label.
Don’ts
Do not use scourers, abrasives, washing powders, chemical cleaners
or any other substances containing abrasives since these substances
can damage the product, including the glass panel.
Never tilt the chair during use.
Do not place very hot or very cold items on the glass surface
unless adequately thick table-mats are used to prevent such
items from coming into contact with the glass.
Do not use the glass as a chopping surface. Do not strike glass
with hard or pointed items.
Do not strike the glass with hard or pointed items.
Do not use power tools to construct this product.
Do not use this product if parts are missing, damaged or worn.
Do not sit or lean on the table.
Do not stand or climb onto the product and do not use it as a ladder,
as this could lead to it unbalancing and overturning.
Never drag furniture when moving it, always lift it.
Number of people required for assembly
Two people
Time to assemble
40 minutes
Tools required


Tips:
Do NOT fully tighten bolts before
all components are connected.
Only fully tighten once you are
satisfied with the alignment of all
components.
Do not overtighten bolts.

Almeria Rattan Corner Sofa Set
Assembly Instructions
ProducedinChinaforAMir&Co.,Ltd.
© A Mir & Co., Ltd. 3 / 11

www.ro
y
alcraft.co.uk
This Coffee Set is a set of 3 pieces.
Please find the member parts.
Member Part
Part No. Diagram Name Qty.
MP1
Coffee Table 1 PC
MP2
2-Seater Sofa 1 PC
MP3
3-Seater Sofa 1 PC
CL
or
Clip(diagram for
reference only) 2 PCS

Almeria Rattan Corner Sofa Set
Assembly Instructions
ProducedinChinaforAMir&Co.,Ltd.
© A Mir & Co., Ltd. 4 / 11

www.ro
y
alcraft.co.uk
Components, fixtures & fittings (not actual size)
Parts List
Part
No.
Diagram Qty.
Part
No.
Diagram Qty.
A
Coffee Table Leg
2 PCS B
Connecting Bar
1 PC
C
Coffee Table Top Frame
1 PC D
Coffee Table Glass Top
1 PC
E
Right Armrest/Leg of
3-Seater Sofa
1 PC F
Left Armrest/Leg of
2-Seater Sofa
1 PC
G
Backrest of 2-Seater Sofa
1 PC H
Seat of 2-Seater Sofa
1 PC
I
Right Leg of 2-Seater
Sofa
1 PC J
Cushion of 2-Seater Sofa
1 PC

Almeria Rattan Corner Sofa Set
Assembly Instructions
ProducedinChinaforAMir&Co.,Ltd.
© A Mir & Co., Ltd. 5 / 11

www.ro
y
alcraft.co.uk
K
Left Leg of 3-Seater Sofa
1 PC L
Backrest of 3-Seater
Sofa
1 PC
M
Seat of 3-Seater Sofa
1 PC N
Cushion of 3-Seater Sofa
1 PC
W20
M6*20mm
4 PCS W35
M6*35mm
25 PCS
W40
M6*40mm
1 PC F10
Bolt Head Cap
30 PCS
F3
Washer
30 PCS S1
Spanner
1 PC
Step by step assembly instructions

Almeria Rattan Corner Sofa Set
Assembly Instructions
ProducedinChinaforAMir&Co.,Ltd.
© A Mir & Co., Ltd. 6 / 11

www.ro
y
alcraft.co.uk
MP1 – Coffee Table
Step One
With the help of another person, place
the Coffee Table Leg (A) upside down
on the ground.
Connect the Coffee Table Top Frame (C)
to the top end of the Coffee Table Leg (A)
using Washers (F3) and Bolts (W35).
Only tighten the bolts when all bolts are
in place and turn freely.
Step Two
Connect them with Connecting Bar (B) using
Washers (F3) and Bolts (W20).
Only tighten the bolts when all bolts are
in place and turn freely.

Step Three
Once you are satisfied with the alignment of the components,
carefully tighten all bolts using Spanner(S1),
then cover all Bolt Heads with Bolt End Caps (F10).
Step Four
Carefully place the Coffee Table Glass top (D)
onto the assembled frame, make surely it fully
rested on the plastic suction caps.
Your Coffee Table is now ready for use.

Almeria Rattan Corner Sofa Set
Assembly Instructions
ProducedinChinaforAMir&Co.,Ltd.
© A Mir & Co., Ltd. 7 / 11

www.ro
y
alcraft.co.uk
MP2 – 2-Seater Sofa
Step One
There is one hook on the side of
the Backrest of 2-Seater Sofa (G).
There is one hole on the
Left Armrest/Leg of 2-Seater Sofa (G).
The hook has to be inserted into
the hole. Please adjust the direction/angle of
the backrest and its hook
in order to align each other.
Loosely attach Backrest of 2-Seater Sofa (G).
to the Left Armrest/Leg of 2-Sater Sofa (F).
using Washers (F3) and Bolts (W35).



Step Two
Loosely attach the Right Leg of
2-Seater Sofa (I) to the Backrest of
2-Seater Sofa (G) using Washers (F3)
and Bolts (W35).
Only tighten the bolts when all bolts are in place
and turn freely.












Almeria Rattan Corner Sofa Set
Assembly Instructions
ProducedinChinaforAMir&Co.,Ltd.
© A Mir & Co., Ltd. 8 / 11

www.ro
y
alcraft.co.uk

Step Three
Loosely attach the Seat of 2-Seater Sofa (H) to the Left Armrest/Leg of 2-Seater Sofa (F), Right Leg of
2-Seater Sofa (I) and Backrest of 2-Seater Sofa (G) using Washers (F3) and Bolts (W35).










Step Four
Once you are satisfied with the alignment of the components, carefully tighten all bolts using
Spanner (S1), cover all Bolt Heads with Bolt End Caps (F10).
Step Five
Place the Cushion of 2-Seater Sofa (J) onto the seat area.
Your 2-Seater Sofa is now ready for use.

Almeria Rattan Corner Sofa Set
Assembly Instructions
ProducedinChinaforAMir&Co.,Ltd.
© A Mir & Co., Ltd. 9 / 11

www.ro
y
alcraft.co.uk
MP3 – 3-Seater Sofa
Step One
Loosely attach Backrest of 3-Seater Sofa (L).
to the Left Leg of 3-Sater Sofa (K).
using Washers (F3), Bolt (W35) and Bolt (W40).










Step Two
Loosely attach the Right Leg of 3-Sater Sofa (I) to the Backrest of 3-Sater Sofa (L) using Washers (F3)
and Bolts (W35).

Only tighten the bolts when all bolts are in place and turn freely.



Almeria Rattan Corner Sofa Set
Assembly Instructions
ProducedinChinaforAMir&Co.,Ltd.
© A Mir & Co., Ltd. 10 / 11

www.ro
y
alcraft.co.uk
Step Three
Loosely attach the Seat of 3-Seater Sofa (M) to the Left /Legs of 3-Sater Sofa (K),
Right Leg of 3-Sater Sofa (E) and Backrest of 3-Seater Sofa (L) using using Washers (F3) and Bolts (W35).


Step Four
Once you are satisfied with the alignment of the components, carefully tighten all bolts using
Spanner (S1), cover all Bolt Heads with Bolt End Caps (F10).
Step Five
Place the Cushion of 3-Seater Sofa (N) onto the seat area.
Your 3-Seater Sofa is now ready for use.