RTA Products Techni Mobili RTA-1819C User manual

Thank you for purchasing our product.
MODEL RTA-1819C
ASSEMBLY INSTRUCTIONS
REV.042021-1

B
x1
G-L
x1
C
x1
F
x5
Seat and Mechanism
(Piece B) with Backrest
(Piece A) pre-assembled
5-Leg star base
Casters
PARTS LIST (NO TOOLS ARE REQUIRED FOR THE ASSEMBLY)
Left armrest (sitting on
the chair, not looking at it)
G-R
x1
Right armrest (sitting on
the chair, not looking at it)
H
x2
Set of screw knob with
O-ring and washer
E
x1
Hydraulic gas lift
P. 1 RTA-1819C P. 1
B
A
BEFORE YOU START THE ASSEMBLY:
❶Do a quick inventory to
make sure the package
contains all the parts listed in
the assembly instructions.
❷Missing, damaged
and defective parts can
be replaced at no cost to
you. Please refer to the
last page in this manual.
❸The replacement parts
service is limited to the
continental United States.
If you reside in Alaska,
Hawaii, Puerto Rico,
U.S. Territories or other
countries, please contact
the supplier from where the
unit was purchased.
❹If during assembly
you find an issue or
need clarification, please
contact our Customer
Service for assistance.
Please refer to the last
page in this manual.

EASY ASSEMBLY STEPS
Insert the casters Finto the
legs of the base Cusing
pressure.
Place the gas lift Ein the
middle of the base C.
STEP 1
STEP 2
STEP 3
P. 2 RTA-1819C P. 2
(Front)
(RIGHT)
(LEFT)
Please note that once assembled,
the arms will have their inclination
towards the front.
(Front)
C
F
E
C
With the seat Bupside-down on the
floor, assemble the armrests G-L and
G-R on the respective sides using the
screw knob / o-ring / washer Has
shown.
B
H
G-L
G-R

Join the base with the seat by inserting the tip of the
gas lift Einto the hole of the mechanism on the seat
Bas shown.
STEP 4
STEP 5
Carefully turn over the chair and
make sure the seat and the base
are secure before sitting.
P. 3 RTA-1819C P. 3
E
B

CHAIR’S FUNCTIONS
1
P. 4 RTA-1819C P. 4
1 -LIFT FUNCTION
On the RIGHT side of the seat there is a lever with a handle and a knob; Pull UP
the handle so the chair can go down while sitting on it, or up if you lift your body.
2 –BACKREST
RECLINING
Turn the knob that is on the LEFT side of the seat COUNTER-CLOCKWISE
(forward) to UNLOCK the reclining function of the backrest so it reclines freely. To
LOCK into any desired angle, just turn the knob CLOCKWISE (backwards). To
UNLOCK and bring to the default upright position, re-adjust the angle, or keep it
reclining freely, turn the knob again COUNTER-CLOCKWISE and recline your
back a little bit.
THIS HANDLE

P. 5 RTA-1819C P. 5
3 – RECLINING
TENSION
Pull OUT the lever that is on the RIGHT side of the seat and turn its knob
CLOCKWISE (forward) to increase the reclining tension for the backrest.
Turn the same knob COUNTER-CLOCKWISE (backwards) to reduce the reclining
tension for the backrest. With less tension, the reclining feels easier.
4 –ARMREST HEIGHT
PUSH the buttons that are on the outside of the armrests and move them UP or
DOWN, then release the buttons when the desired height has been reached.
+
-

P. 6 RTA-1819C P. 6
5 –ARMREST DEPTH
MOVE the armrest pads FORWARD or BACKWARDS to adjust their depth.
6 –ARMREST ANGLE
Swivel the armrests pads IN or OUT according to your preference.
INWARDS
OUTWARDS

WARNINGS
• Do not exceed the indicated weight limit.
• Do not stand up on the chair or use it as ladder.
• Only one person at a time can sit on the chair.
• Do not use the chair if parts are damaged or if screws are loose or missing.
• Do not sit near the edge of the seat to avoid going beyond your balance point and falling
off the chair, and always sit properly.
• If small children are sitting on the chair, please keep close observation on them.
• Do not allow small children to play with the chair.
• Not paying attention to these warnings could result in injuries.
•To clean the chair it is recommended to use a soft cloth lightly damped in a solution of
smooth soap and water, then dry with a clean towel.
•Do not use solvents or abrasive materials to clean any part of the chair.
•Before applying a cleaning agent, test on a small hidden area of the chair, like
underneath the seat.
•Do not expose the product to direct sunlight or to extreme environmental conditions.
•Every 4 months, inspect the chair completely and make sure that all screws are
tighten.
CARE AND MAINTENANCE
P. 7 RTA-1819C P. 7
Weight
Limit:
285 Lbs

TECHNI MOBILI CHAIR WARRANTY
TASK/KID'S CHAIR: 1-YEAR WARRANTY
EXECUTIVE/MANAGER CHAIR: 2-YEAR WARRANTY
1.RTA Products, LLC has warranted the Techni Mobili office chairs to the original purchaser who
acquired a new product from RTA Products or its authorized resellers of the product against defects in
material or workmanship.
2.This warranty is expressly limited to the repair or replacement (at its option) of defective chair
components or materials that fails under normal use as a result of a defect in materials or workmanship.
This warranty is limited to merchandise purchased in the Continental United States. No assembly labor
is included. The word "defects" as used in this warranty, is defined as imperfections that impair the
utility of the product.
3.This warranty applies under conditions of normal use, but does not apply to defects that result from
intentional damage, negligence, unreasonable use or exposure.
4.Liability for consequential damages is excluded to the extent exclusion is permitted by law. This
warranty gives you specific legal rights, and you may have other rights that vary from State to State.
5.RTA Products does not warrant: a) natural variations in character marks b) changes in surface
finishes due to aging or exposure to light c) marks, scars, or wrinkles occurring naturally in leather d)
failure resulting from normal wear and tear e) the matching of colors, grains, or textures of natural
materials f) the colorfastness or the matching of textiles, including an exact match to cuttings or to
swatch cards g) damage, marking, or staining of veneer surfaces due to contact with rubber or similar
compounds, damage from sharp objects or imprinting from writing instruments, or prolonged exposure
to direct sunlight h) we do not warrant products that are exposed to extreme environmental conditions
or that have been subject to improper storage.
6.RTA Products shall not be liable for loss of time, inconvenience, commercial loss, or incidental or
consequential damages.
7.Any modification to the original product voids the warranty. We do not warrant the performance of the
product when used in combination with other than original products.
8.This product has been designed for and is intended for office and home-office use only. This warranty
is Original Purchaser’s sole remedy for product defects, and this warranty does not extend to any
product, or damage to any product, caused by or attributed to abuse or misuse, products used for
commercial or rental purposes, use modifications of, or attachments to the product, and products or
parts not used, maintained, or extended hereunder is in lieu of any and all other warranties, express or
implied, including without limitations any implied warranty or merchantability or of fitness for a particular
purpose.
9.Report any defects to RTA Products, LLC together with your sales receipt or other proof of purchase.
If the chair is defective within the terms of the warranty, RTA Products, LLC will furnish a replacement
chair (at its option) at no cost of equal or similar value and design.
10.RTA Products will advise you of the procedure to follow in making warranty claims. The following are
the procedures for warranty claims:
a) Call us Monday –Friday, from 9am-5pm (Eastern Time) at [phone] to explain the defect and
give your name, address and phone number. Please have ready the model number of our product, date
and place of purchase. You can also write to us by e-mail to [e-mail] and include the
same information.
b) If we determine that replacement will remedy the situation, and in order to determine the extent or the
cause of the defect, purchaser will need to send the part in question at purchaser’s expense. Once we
receive the part, we will examine it and determine whether the claim is valid (or not), and then proceed
to send the replacement. We will ship the replacement at our expense.
P. 8 RTA-1819C P. 8

FOR SEVERAL HELP OPTIONS
INCLUDING REPLACEMENT PARTS ORDERS
_________________________________________________________________
VISIT: WWW.TECHNIMOBILI.COM
CLICK ON SUPPORT TAB
Scan QR Code to order replacement parts
OR EMAIL US: [e-mail]
P. 9 RTA-1819C P. 9