RTA Products Techni Mobili RTA-470FC User manual

Thank you for purchasing our product.
MODELS
RTA-470FC, RTA-471FC
ASSEMBLY INSTRUCTIONS
REV.052021-0
RTA-470FC RTA-471FC

AB CD
Seat/back Bottom leg frame Top leg frame
MAIN PARTS LIST
LIST OF HARDWARE
PART
QTY PER
CHAIR
TOTAL
IN BOX ITEM USE IN
E1 2 M6x30 Step 1
F48M6x45 Step 2
1Allen Wrench Steps 1 and 2
P. 1 RTA MODELS: 470FC, 471FC P. 1
Per chair: 1
Total in box: 2
Per chair: 1
Total in box: 2
Per chair: 1
Total in box: 2

BEFORE YOU START THE ASSEMBLY, PLEASE READ THE FOLLOWING TIPS
AND WARNINGS.
❶Do a quick inventory to
make sure the package
contains all the parts and
hardware listed in the
assembly instructions.
❷Missing, damaged
and defective parts can
be replaced at no cost to
you. Please refer to the
last page in this manual.
❹If during assembly
you find an issue or
need clarification,
please contact our
Customer Service for
assistance. Please refer
to the last page in this
manual.
❺On each step read
the instructions and
analyze the
illustrations thoroughly
before proceeding to
do the assembly.
❽Do not overtighten
or force the screws as
they might break, strip,
damage the threads of
the holes or get stuck
inside the part.
❻Make sure you
understand which hardware
will be used on each step.
Using the wrong size of
screw, bolt or pin might
strip the threads or cause
damage to the part in which
it is being used.
❼To avoid
misalignments, always
leave the screws loose
and tighten them until
all pieces are
positioned correctly.
❾If the hole seems too big or too small for the
screw, first make sure you are using the correct
size of screw and that it’s been installed in the
correct hole. Test another of the same screw
into the same hole, as well as test the screw
onto different holes for the same part. If the
hole still appears to be too small, do not force
it, it needs replacing.
P. 2 RTA MODELS: 470FC, 471FC P. 2
❸The replacement parts
service is limited to the
continental United States.
If you reside in Alaska,
Hawaii, Puerto Rico,
U.S. Dependencies or other
countries, please contact
the supplier from where the
unit was purchased.

ASSEMBLY STEPS (FOR EACH CHAIR)
Attach the bottom leg
frame Cto the top leg
frame Dwith screw Eas
shown, but leave it loose
to allow flexibility for the
next step.
Turn over the seat AB with
its front end towards you,
and place over the leg
frames C/D and assemble
them with screws F,
making sure the arrows on
both legs point towards the
front of the chair as
shown.Then proceed to
tighten all the screws.
Place the unit upright on a
flat level surface, and adjust
the leveling of the legs by
turning the bottom glides in
either direction.
P. 3 RTA MODELS: 470FC, 471FC P. 3
STEP 3
STEP 1
Hardware
E
M6x30
1
Pc
STEP 2
Hardware
F
M6x45
4
Pcs
(Front)
C
D
E
IMPORTANT:
The arrows on both legs
must point towards the
front of the chair.
C
(Front)
D

WARNINGS
CARE AND MAINTENANCE
P. 4 RTA MODELS: 470FC, 471FC P. 4
• Do not exceed the indicated weight limit.
• Do not stand up on the chair or use it as ladder.
• Only one person at a time can sit on the chair.
• Do not use the chair if parts are damaged or if screws are loose or missing.
• Do not sit near the edge of the seat and always sit properly on the chair to avoid going beyond
your balance point and falling off the chair.
• If small children are using the chair, please keep close observation on them.
• Do not allow small children to play with the chair.
• Not paying attention to these warnings could result in injuries.
•To dust off the fabric, use a brush with very soft bristles or a feather–like duster. If you use a
vacuum cleaner, make sure it is set at the lowest speed or power setting.
•To clean small areas of the fabric, use a soft cloth lightly damped in a solution of smooth soap
and water and do not rub the material, instead, dab and dry immediately with a clean soft towel.
•When cleaning the fabric, avoid pressing hard against the cushioning to avoid the internal foam
getting wet.
•Do not use solvents or abrasive materials to clean any part of the chair. Use cleaning agents at
your own risk.
•The unit is intended to be used indoors only.
•Do not expose the product to direct sunlight, high humidity or to extreme environmental
conditions.
•Every 4 months, inspect the chair completely and make sure that all screws are tighten.
Weight
Limit:
250 Lbs

1.RTA Products, LLC has warranted the Techni Mobili office chairs to the original purchaser
who acquired a new product from RTA Products or its authorized resellers of the product
against defects in material or workmanship.
2.This warranty is expressly limited to the repair or replacement (at its option) of defective
chair components or materials that fails under normal use as a result of a defect in materials
or workmanship. This warranty is limited to merchandise purchased in the Continental United
States. No assembly labor is included. The word "defects" as used in this warranty, is defined
as imperfections that impair the utility of the product.
3.This warranty applies under conditions of normal use, but does not apply to defects that
result from intentional damage, negligence, unreasonable use or exposure.
4.Liability for consequential damages is excluded to the extent exclusion is permitted by law.
This warranty gives you specific legal rights, and you may have other rights that vary from
State to State.
5.RTA Products does not warrant: a) natural variations in character marks b) changes in
surface finishes due to aging or exposure to light c) marks, scars, or wrinkles occurring
naturally in leather d) failure resulting from normal wear and tear e) the matching of colors,
grains, or textures of natural materials f) the colorfastness or the matching of textiles,
including an exact match to cuttings or to swatch cards g) damage, marking, or staining of
veneer surfaces due to contact with rubber or similar compounds, damage from sharp objects
or imprinting from writing instruments, or prolonged exposure to direct sunlight h) we do not
warrant products that are exposed to extreme environmental conditions or that have been
subject to improper storage.
6.RTA Products shall not be liable for loss of time, inconvenience, commercial loss, or
incidental or consequential damages.
7.Any modification to the original product voids the warranty. We do not warrant the
performance of the product when used in combination with other than original products.
8.This product has been designed for and is intended for office and home-office use only.
This warranty is Original Purchaser’s sole remedy for product defects, and this warranty does
not extend to any product, or damage to any product, caused by or attributed to abuse or
misuse, products used for commercial or rental purposes, use modifications of, or
attachments to the product, and products or parts not used, maintained, or extended
hereunder is in lieu of any and all other warranties, express or implied, including without
limitations any implied warranty or merchantability or of fitness for a particular purpose.
9.Report any defects to RTA Products, LLC together with your sales receipt or other proof of
purchase. If the chair is defective within the terms of the warranty, RTA Products, LLC will
furnish a replacement chair (at its option) at no cost of equal or similar value and design.
10.RTA Products will advise you of the procedure to follow in making warranty claims. The
following are the procedures for warranty claims:
a) Call us Monday –Friday, from 9am-5pm (Eastern Time) at [phone] to explain the
defect and give your name, address and phone number. Please have ready the model
number of our product, date and place of purchase. You can also write to us by e-mail
to [e-mail] and include the same information.
b) If we determine that replacement will remedy the situation, and in order to determine the
extent or the cause of the defect, purchaser will need to send the part in question at
purchaser’s expense. Once we receive the part, we will examine it and determine whether the
claim is valid (or not), and then proceed to send the replacement. We will ship the
replacement at our expense.
P. 6 RTA MODELS: 470FC, 471FC P. 6
TECHNI MOBILI CHAIR WARRANTY
TASK/KID'S CHAIR: 1-YEAR WARRANTY
EXECUTIVE/MANAGER CHAIR: 2-YEAR WARRANTY
DINING CHAIRS: 1-YEAR WARRANTY

FOR SEVERAL HELP OPTIONS
INCLUDING REPLACEMENT PARTS ORDERS
_________________________________________________________________
VISIT: WWW.TECHNIMOBILI.COM
CLICK ON SUPPORT TAB
Scan QR Code to order replacement parts
OR EMAIL US: [e-mail]
P. 7 RTA MODELS: 470FC, 471FC P. 7