Rugged Ridge 11503.95 User manual

Copyright © 2013 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [email protected]
07+ JK CB Mount
2. For 2007-2010 model JK’s: drill out rivets using
3/8” drill bit. Rivets will be replaced with Well Nuts.
3. For 2011+ model JK’s: remove center footman
loop by removing (2) Torx Screws.
1. CB Mounting Bracket (1)
2. M5 Well Nut (2)
3. M5x20 Philips Head Machine Screw (2)
4. M5x12 Philips Head Machine Screw (2)
5. M5 Locking Hex Nut (2)
1. #2 Philips Head Driver
2. T-25 Torx Driver, or T-15
Torx Driver
3. 3/8” Drill Bit
4. Drill
1. Position sun visors against side windows. Remove
center portion of plastic windshield frame cover by
gently pulling down until the clips release.
Page 1/2
11503.95
Components:
Required Tools:
OMIX-ADA®TECHNICAL SUPPORT
PHONE: M-F 8am - 5pm EST 1-800-449-6649 | EMAIL: [email protected]
FOR WARRANTY INFORMATION VISIT: www.Omix-Ada.com
Read all instructions thoroughly before installation.
Rev 09/2013
Be careful not to drill too deep, you may
damage other side of windshield frame.
NOTICE

Copyright © 2013 Omix-Ada®, Inc.
460 HORIZON DR. SUITE 400 | SUWANEE, GA 30024 | PHONE: [phone] | FAX: [phone] | [email protected]
07+ JK CB Mount
7. Replace center plastic windshield frame cover.
Install CB Mount, radar dectector, or GPS device
using M5x15 bolts and Locking Hex Nuts.
5. For 2007-2010 model JK’s: use provided M5x20
screws to install CB Mount and footman loop with
CB Mount on outside.
6. For 2011+ JK’s: use factory Torx screws to install CB
Mount and footman loop with CB Mount on outside.
4. For 2007-2010 model JK’s: insert Well Nuts into
newly drilled holes in sheet metal. If drilled holes are
too large to snuggly t Well Nuts, secure with small
amount of super glue.
Page 2/2
11503.95
Make sure any installed devices are se-
cure, and safe. Do not obstruct rear view
mirror.
NOTICE