Samsara AG24 User manual

Asset Gateway
POWERED ASSET INSTALL GUIDE
Questions? samsara.com/support
1× Mounting
Plate
1x Accessory
Wire
1x Power
Cable
1× Asset
Gateway
What’s included:
4x Flat-End
Screws
Ring
Terminals
4x Self-Tapping
Screws
Zip
Ties

Securely attach AG24 to asset:
1Choose location for installation depending on
asset type and use case:
• To enable solar recharging, choose a position facing
the sun
• To reduce theft and detection, secure inside the
engine compartment
• Attach mounting plate using adhesive and secure with
4 self-tapping screws (provided)
• Secure AG24 to mounting plate using 4 flat-end
screws (provided)
• Connect the red wire labeled power to the continuous
power source (i.e. battery positive terminal).
• Connect the black wire labeled ground to the ground
(i.e. battery negative terminal).
2
5To detect when the ignition is on:
• Connect the yellow wire labeled ignition to the
switched power source
• If yellow wire is too short, extend with accessory wire
• When ignition is off, the relay prevents vehicle power
drain. AG24 will function on internal battery for up to 3
months
6Secure the cable (optional)
3Plug cable into AG24: 4To power the AG24:
• Use zip ties (provided) to ensure that the cable does
not obstruct activity
• Twist to secure
• Light turns on when activated
Relay Ignition Ground
Power
Vehicle Battery
* For questions about the safe use of lithium battery powered devices, please consult your company’s safety department.
*