Samsung SMT-i5264 Service manual

ITP-5112L IP 전화기 사용설명서
IP AOM Network Setting Guide
SMT-i5264

2 © SAMSUNG Electronics Co., Ltd.
S
Sa af fe et ty y C Co on nc ce er rn ns s
For product safety and correct operation, the following information must be given to the
operator/user and shall be read before the installation and operation.
.
Symbols & Conventions
Caution
Indication of a general caution
Restriction
Indication for prohibiting an action for a product
Instruction
Indication for commanding a specifically required action.
Note
Indicates additional information for reference.

ITP-5112L IP 전화기 사용설명서
© SAMSUNG Electronics Co., Ltd. 3
WARNING
Pull out the power plug when
the IP AOM is not used for a
long time or bad weather
condition.
Failure to do so may cause fire or
electric shock.
Be sure to connect the power
connection port to the power
adapter offered with the phone.
The use of another adapter may
cause the critical damage to the
phone..
Do not use damaged power
plug or cord, or loose outlet.
Failure to do so may cause fire
or electric shock.
Do not pull or bend power plug
by force.
Do not touch the power plug
with wet hands.
Failure to do so may cause the
damage to power plug or fire,
electric shock.
Do not place vases, flowerpots,
cosmetics, or medicine, which
contain water, near the IP AOM.
Failure to do so may cause fire or
electric shock.
Do not leave the IP AOM in
dusty areas and near a
heating devices (heater or
light for cigarette). Install in
the place well ventilated.
Failure to do so may cause fire
or electric shock.
Do not use or keep flammable
spray or materials near the IP
AOM.
Failure to do so may cause fire
or explosion.
Pull out the power plug and brush
it with a cloth if the contact
surface with power plug pins is
dusty or gets wet. Contact the
service center if the foreign
materials or water is not removed
even after brushing.
Failure to do so may cause fire or
electric shock.
Pull out the telephone line at
once and contact the service
center if unusual sound,
smell, or smoke comes out.
Failure to do so may cause fire
or electric shock.

4 © SAMSUNG Electronics Co., Ltd.
CAUTION
Be sure to connect the LAN cable
linked to network to the LAN
connection port of the phone,
not to the PC-connection port of
the phone.
If the LAN cable is connected to
the PC connection port, the
phone or PC communication will
be out of service.
Do not spray water directly or do
not use chemical solvents such
as wax, benzene, alcohol,
thinner, mosquito spray, aerosol,
lubricant, and detergent.
Failure to do so may cause the
damage to the product..
Do not put heavy materials on
the IP AOM.
Failure to do so may cause the
damage to the parts of the IP
AOM or fire.
Do not turn off the power while
the IP AOM is upgrading its
software.
Failure to do so may interrupt the
upgrades by stopping the
operation of the telephone.
Do not place the IP AOM under
direct sunlight.
Failure to do so may cause
product damage and product
does not operate properly.
Do not separate, repair, or
remodel at your discretion.
Failure to do so may cause
product damage.

ITP-5112L IP 전화기 사용설명서
© SAMSUNG Electronics Co., Ltd. 5
T
TA AB BL LE E O OF F C CO ON NT TE EN NT TS S
SAFETY CONCERNS 2
SYMBOLS &CONVENTIONS ...................................... 2
IP AOM SYNOPSIS 6
ABSTRACT ....................................................... 6
CONFIGURATION ................................................ 6
NETWORK SETTING ............................................. 7
Using IP Phone ...............................................................................7
Using Web management page (HTTP) .................................. 13
Auto registration using PnP(Plug and Play) ........................ 15
Error check with LED status .................................................... 17
LED status during S/W upgrade ............................................. 18
ANNEX 19
SPECIFICATION ................................................ 19
Removal of Stand ....................................................................... 20
IP AOM Ports ............................................................................... 21
Connection with IP Phone ........................................................ 22
Connection with Switch ............................................................. 23

6 © SAMSUNG Electronics Co., Ltd.
I
IP P A AO OM M S Sy yn no op ps si is s
Abstract
IP AOM co-works with IP phones such as ITP-51XX for OfficeServ and SMT-i52XX
for OfficeServ and SCM, it has 64 buttons. IP AOM provides various services using
short dial. It is more convenient. It helps users to improve office communication.
Configuration
Notice
1) IP AOM doesn’t supply PoE power to IP Phone when it’s only connected with power
adaptor. In this case, IP Phone must be connected with a power adaptor.
2) Several IP AOMs must be connected to switch separately. It doesn’t supply direct
connection to each other.
3) ☎ port of IP AOM doesn’t supply the connection with PC.

ITP-5112L IP 전화기 사용설명서
© SAMSUNG Electronics Co., Ltd. 7
Network Setting
Using IP Phone
I P A O M
- After rebooting, press Key 5 until LED 8 and LED 12 blink for config mode.
- Press Key 12.
- Waiting for completion of setting from IP phone.
※ Configure only one IP AOM at a time.

8 © SAMSUNG Electronics Co., Ltd.
Configuration is initialized if key 8 is pressed.
. mode : DHCP (PnP mode not DHCP mode. Page15)
. IP address : 10.0.0.3
Configuration is changed to default if key 12 is pressed.
. mode : STATIC
. IP address : 10.0.0.3

ITP-5112L IP 전화기 사용설명서
© SAMSUNG Electronics Co., Ltd. 9
IP Phone – ITP-5112L
- 3. Network Setup → 7. IP AOM Setup
Network Setup
1. Manual IP
2. DHCP
3. PPPoE
4. VLAN Setup
5. TOS
6. 802.1X
7. IP AOM Setup
- Select “7. IP AOM Setup” IP Phone sends AOM_ALIVE_REQ and waits for
response.
- After response IP Phone sends configured values. (Display of error message when
no response)
- Input correct value at each step.
- Do not need IP, Subnet and Gateway when using DHCP mode.
IP AOM Setup
1. Manual IP
2. DHCP
IP AOM Setup - Manual IP
IP
192.168.0.99

10 © SAMSUNG Electronics Co., Ltd.
IP AOM Setup - Subnet
Subnet
255.255.255.0
IP AOM Setup - Gateway
Gateway
192.168.0.1
IP AOM Setup - Server IP
Server IP Address
192.168.0.2
IP AOM Setup - ID
Phone ID
1001
IP AOM Setup - Password
Password
****
→ Do not need Phone ID and Password on SCM. They are for OfficeServ.

ITP-5112L IP 전화기 사용설명서
© SAMSUNG Electronics Co., Ltd. 11
IP AOM Setup - Port(IAP Only)
Port Number
00000041
→ Port number is 8 hexa code just for SCM. (any number for OfficeServ)
- After completion, IP phone sends configured value to IP AOM.
IP AOM Setup - Ready
Press Enter to Send Info !!
- When completion (AOM_INFO_SET_OK receive), IP AOM reboots and tries to apply
settings.
Setup Success !!!
Press Enter to Return !!
- When no response, IP phone shows error message bellow.
AOM No Answer !!!
Press Enter to Return !!
AOM Setup Fail !!!

12 © SAMSUNG Electronics Co., Ltd.
Press Enter to Return !!

ITP-5112L IP 전화기 사용설명서
© SAMSUNG Electronics Co., Ltd. 13
Using Web management page (HTTP)
I P A O M
- Connect to Web management page of IP AOM (default IP is 10.0.0.3) to set network.
- If IP AOM is working it can be connected to current IP address.
Screen for connect to HTTP
- http://10.0.0.3:8080 (port number is 8080)
- Initial ID : admin, password : samsung

14 © SAMSUNG Electronics Co., Ltd.
- Reboot after changing the value to need.
 IP AOM IP Address, Subnet Mask, Default Gateway
 Server IP Address, ID / Password
 VLAN, 802.1x
 Image Upgrade

ITP-5112L IP 전화기 사용설명서
© SAMSUNG Electronics Co., Ltd. 15
Auto registration using PnP(Plug and Play)
IP AOM provides PnP. This makes IP AOM register to PBX system automatically without
additional setting. This uses DHCP mode. Therefore do not need IP, netmask, gateway
settings. (Now, it is for only OfficeServ7200/7400)
Network environment and DHCP server config.
- It must be follow below setting to operate properly.
- Use below DHCP options to prevent to get IP address from other DHCP server.
※ DHCP Server config. (DHCP server option config. option config is different for
every DHCP server.)
→ DHCP_Server_Name(66): "SEC_ITP"
→ DHCP_Server_IP(128): OfficeServ IP

16 © SAMSUNG Electronics Co., Ltd.
System MMC Settings
- Pre-setting IP AOMs MAC address for user ID on MMC840.
(A~F are capitalized for MAC address)
[3001]USER ID
001632C57B84
[3002]USER ID
001632C53729
- After completion make IP AOM factory reset.

ITP-5112L IP 전화기 사용설명서
© SAMSUNG Electronics Co., Ltd. 17
Error check using LED status
AOM
LED status
Description
Measures & Check items
LED1 ~ LED4 are
blink
No response against
trying to register to
system.
- check system is
alive
- check network
information of
terminal and system
One of LED5 ~
LED16 is blink.
(LED1 ~ LED4
are blink at
the same time)
Error response from
system
(different LED is
blink depends on error
cause)
- check user ID &
password
LED37 ~ LED40 are
On
Disconnected to LAN
port.
- check LAN port or
cable
LED49 ~ LED52
are On
AOM could not get IP
address from DHCP
server at DHCP mode
- check DHCP server
LED61 ~ LED64
are blink
IP conflict - check AOM’s IP
address or other IP
devices nearby.

18 © SAMSUNG Electronics Co., Ltd.
LED status during S/W upgrade
AOM
LED status
Description
Measures & Check items
LED1 ~ LED12 are
on sequent.
Downloading image from
TFTP server and write
it on flash memory.
LED13 ~ LED24 are
on
Complete to write
image.
LED13 ~ LED24
are blink.
Fail to upgrade s/w. - check TFTP server
settings
- check connecting LAN
port or cable
- retrying after
reboot

ITP-5112L IP 전화기 사용설명서
© SAMSUNG Electronics Co., Ltd. 19
A
AN NN NE EX X
Specification
Item Description
Model Name
SMT-i5264
Weight(kg)
0.59
Size(mm)
137(W)
×
225(D)
×
108(H)
Power
Input Voltage
AC 100V~240
V/50Hz~60
Hz ; 0.5
A
Output Voltage DC 5 V ; 3 A
Adaptor
Ten Pao Co. PN:S018EU0500300
POE Input Voltage
DC 48V ; 0.2A
POE Spec.
IEEE 802.3af standard (CLASS 3)
Temperature(℃)
0~45
Humidity(%)
10~90
Number of Buttons
64

Removal of Stand
받침대의 각도 70 도일 경우에도 동일한 방법으로 분리합니다.