Satel PDB-100 User manual

DETECTOR BASE
DB-100
INDUSTRIAL SPACER
PDB-100
db-100_en 06/15
SATEL sp. z o.o.
ul. Budowlanych 66
80-298 Gdańsk
POLAND
tel. + 48 58 320 94 00
www.satel.eu

1. General
The DB-100 base (Fig. 1) allows you to install and connect the DMP-100,
DRP-100 and DCP-100 conventional detectors to the fire alarm control panel.
The wires to be connected to the base can be either concealed or surface
mounted.
The DB-100 base can be installed by means of the intermediate PDB-100
industrial spacer (Fig. 2). The use of the industrial spacer is recommended for
installing detectors in spaces where the phenomenon of water vapor
condensation may occur on the ceiling.

2 DB-100 ●PDB-100 SATEL
2. DB-100 base wiring
Disconnect power before making any electrical connections.
Connect wires to the screw terminals marked with the following numbers:
1 – terminal „-”;
2 – terminal "-", dedicated for remote alarm indicator;
3 – terminal „+”;
4 – terminal „+”;
5 – terminal dedicated for screen connection.
Fig. 4 shows a typical connection.

SATEL DB-100 ●PDB-100 3
3. Specifications
3.1 DB-100 detector base
Dimensions....................................................................................ø106 x 26 mm
Weight.......................................................................................................... 52 g
3.2 PDB-100 industrial spacer
Dimensions............................................................................131 x 131 x 35 mm
Weight.......................................................................................................... 76 g