Seaside Casual Newport 5' Bench User manual

Page 1
REV B
Seaside Casual Furniture | 11 Industrial Drive Coventry, RI 02816 | 800-809-3114 | [e-mail]
1PLEASE READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING.
Carefully remove contents from box. Make sure that all parts and hardware
are included using the Parts List below.
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
Part Code: 316-8x3/4PPS
Actual Size
3/4” Phillips Pan Head
Back Assembly
x 1
Right & Left Side Assemblies
80mm Hex Lag
Seat Assembly
x 1
Part Code: 4MMALLEN
Actual Size
4mm Allen Wrench
x 1
x 18
x 9
Newport 5’ Bench
(137)
Part Code: 316-1/4-10-80HL
x 1
ASSEMBLY INSTRUCTIONS
4mm Allen Wrench (included); #2 Phillips Head Screwdriver; Rubber Mallet.
Tools Required:
Part Code: 316-8X1-1/4PFDS
Actual Size
1-1/4” Phillips Head Screw
x 4
Actual Size
Lower Stretcher
x 1
5/8“
Right Left
Actual Size
Bungs
x 18

Page 2
REV B
2ATTACH SIDE ASSEMBLIES TO
SEAT ASSEMBLY
Align Left Side
Assembly with
seat assembly.
Secure using (2)
80MM Hex Lags
through the
c o un te r -b o r ed
holes in front leg into pilot holes in front
apron of seat assembly. Plug holes with
(2) 5/8” Bungs using rubber mallet.
Repeat process for Right Side.
Align counter-
bored holes in
Rear Left Leg
with Pilot holes in
Back Assembly,
ensuring that the
counter-bores in lower back are facing
outward. Attach using (3) 80mm Hex
Lags. Plug holes with (3) 5/8” Bungs us-
ing rubber mallet.
Repeat process for Right side.
Turn Assembly
upside down. Se-
cure aluminum
seat cleat to low-
er back using (9)
3/4” Phillips Pan Head Screws.
3ATTACH BACK TO REAR LEGS
5SECURE REAR SEAT CLEAT
TO LOWER BACK
Secure Lower
Back Assembly
to Seat Assembly
using (4) 80MM
Hex Lags thru
counter-bored
holes in lower back into pilot holes in seat
supports. Plug holes with (4) 5/8” Bungs
using rubber mallet.
4ATTACH BACK ASSEMBLY TO
SEAT

Page 3
REV B
6ATTACH SEAT CLEAT TO SIDE
ASSEMBLY
Align counter-bored
holes in lower side
stretcher with Pilot
holes in long stretch-
er, making sure that
the aluminum in the long stretcher is fac-
ing down. Attach using (2) 80mm Hex
Lags. Plug holes with (2) 5/8” Bungs us-
ing rubber mallet.
Repeat process for other side.
7ATTACH STRETCHER TO SIDE
ASSEMBLIES
TIGHTEN ALL CONNECTIONS. AVOID OVER TIGHTENING; DOING SO
CAN CAUSE DAMAGE TO THE PRODUCT.
8
Secure outer seat
cleat to side assembly
using (2) 1-1/4” Phil-
lips Head Screws.
Repeat Process for other side.