Seaside Casual Cambridge Sectional Armless 002 User manual

1
Tools Required:
Phillip's Head Screwdriver
4MM Allen Wrench (Included) or
Screw Gun with 4MM Driver (Not Included) (Recommended)
Hardware:
(8) 3” Hex 1/4” Lags
(8) 1-1/4” Phillip’s Head Screws (001)
(4) 1-1/4” Phillip’s Head Screws (002)
(0) 1-1/4” Phillip’s Head Screws (003)
(12) 1-1/4” Phillip’s Head Screws (004)
001 (3) Long Legs & (1) Short Leg
(1) Seat Assembly
Parts List:
Assembly Instructions
Step One: Set Up
READ ENTIRE INSTRUCTIONS BEFORE BEGINNING! Carefully remove contents
from box. Make sure that all parts and hardware are included.
This assembly requires two people
Lay top rail upside down on a clean flat surface with insert nuts
showing. Insert top of leg with a hanger bolt into the insert nuts
in the top rail. Then spin the leg clockwise till its tight and square
with the top rail (Right Picture). Once you feel tension, continue
to turn until notches for back slats are aligned with top rail. Re-
peat process for all long legs per item.
Corner Leg will be marked C in the large notch for the seat.
Right & Left Leg will be marked R&L in the large notch for the
seat.
Step Two: Long Leg Assembly (001,002,004 Only)
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
Instruction Revision: A
Back Slats (4) 001, (2) 002, (6) 004
(1)Top Rail (001,002,004 Only)
004 (4) Long Legs
002 (2) Long Legs & (2) Short Leg
003 (4) Short Legs

2
Tighten all connections. Do not over tighten!!! Over tightening of hardware can cause
damage to the item.
Step Four: Seat Assembly (001,002,004 Only)
Step Six: Tightening of Hardware
Step Three: Back SlatsAssembly (001,002,004 Only)
Align back slats in between legs with
pocket facing up. Tap into notches on each
side of the leg. Secure using (2) 1-1/4”
Phillip’s head screw. Attach one back slat
at a time from the bottom up. Repeat proc-
ess for all back slats.
Slide seat assembly into notches on long
legs with notches on outer seat slats to-
wards long legs. For 001 and 004 you will
have to pull front legs out slightly to fit seat
in. Secure all long legs with (2) 3” hex 1/4
lags each using a 4MM Allen Wrench or Screw
Gun with 4MM Driver.
Step Five: Short Leg Assembly (001,002,003 Only)
Align short legs into corners flush up to the
seat slats. Secure all short legs with (2) 3”
hex 1/4 lags each using a 4MM Allen Wrench
or Screw Gun with 4MM Driver.