Seaside Casual HIP 410 User manual

Page 1
Seaside Casual Furniture | 11 Industrial Drive Coventry, RI 02816 | 800-809-3114 | [e-mail]
1PLEASE READ INSTRUCTIONS COMPLETELY BEFORE BEGINNING.
Carefully remove contents from box. Make sure that all parts and hardware are in-
cluded using the Parts List below.
WARRANTY QUESTIONS OR COMMENTS PLEASE CALL TOLL FREE AT 1-800-809-3114
BACK
x 1
ARMREST
50mm HEX LAG
FRAME
x 1
Part Code: 4MMALLEN
Actual Size
4mm ALLEN WRENCH
x 1
HIP CHAIR
410
Part Code: 316-1/4-10-50HL
x 1
ASSEMBLY INSTRUCTIONS
4mm Allen Wrench (included); #2 Phillips Head Screwdriver;
(Recommended: Rubber Mallet; Power Drill)
Tools Required:
Actual Size
1-5/8” PHILLIPS HEAD SCREW
Actual Size
3/4” PHILLIPS PAN HEAD SCREW
x 6
SEAT
x 1
x 4
x 6 Part Code:
Actual Size
BUMPER
Part Code:
x 4

Page 2
2ATTACH SEAT
On a clean flat surface push seat tight to
the front of the chair frame. Attach Seat
with (6) 3/4” Phillips pan head screws.
Secure Bumpers in locations shown. Do
not over tighten.
On a clean flat surface align armrest
with slot and attach using (3) 1 5/8”
Phillips head screws. Repeat on opposite
side. Do not over tighten.
3ATTACH ARMRESTS
Align pilot holes in rear yokes of Back
with the holes in the Chair frame. Secure
with (4) 50mm Hex lags. Do not over
tighten.
4ATTACH BACK