Sega Nascar Arcade Mini Standard User manual

134
™May 15, 2002
SERVICE BULLETIN
SEGA SERVICE DEPARTMENT http://www.serservice.com
45133 Industrial Drive Phone: [phone]
Fremont, Ca. 94538 Fax: [phone]
SPECIAL NOTICE FOR ALL
MINI STANDARD
Nascar Shifter Reinforcement Kit
Installation Instructions
1. Remove the 4 Tamper Proof screws securing the shifter plate and remove the shifter
plate. Note: Save all parts removed for re-installation process.
2. Remove the 4 bolts securing the shifter ease the shifter out, unplug it from the game and
remove the shifter.
3. Using the template provided, drill four 5/16” bracket mounting holes in the top of the
console. (see gure below)
Page
1 of 4

2
www.seuservice.com
134
134
4. Using the template provided, drill two 9/32” bracket mounting holes in each side of the
console as shown.
5. Using the four-20 X 1” Carriage Bolts, nuts & washkers provided, mount each of the two
brackets to the inside walls of the console as shown. Note: Do not tighten the nuts yet.
The holes drilled in the top of the wood console should align with the tapped holes in the
bracket.
Page
2 of 4

2
www.seuservice.com
134
134
6. Using the four - 20 X 1” at-head machine screws provided, secure the top each of the
brackets to the wooden console as shown below, then tighten the nuts on the carriage
bolts.
7. Place the 2 spacer plates as shown below left, and then plug in the shifter re-install the
shifter assembly using the same 4 hex bolts removed earlier.
Page
3 of 4

4
www.seuservice.com
134
8. Re-install the shifter plate using the 4 Tamper Proof screws you removed earlier. Page
4 of 4