Siemens SPC 4300 User manual


DualCom Pro
Siemens/Vanderbilt
SPC 4300
CSL1793V2 27082020
Panel Connection – MCM
Manufacturer Siemens/Vanderbilt
Model SPC 4300
MCM MCM version greater or equal to V1.06
Panel Firmware Range V2.1.0
Cable Required? MCM
Panel Profile Vanderbilt-SPC-MC
Panel Bus Connection None
Technical Notes See below
Panel Connection Information
DualCom Pro
MCM
Siemens/Vanderbilt
(PC137421 MCM Unit)
A A
B B































Panel Programming
Default Keypad Login code = 1111
Login to panel > “Full Engineer” will be displayed > Press “Select” button > “System Status” will
be displayed
Scroll down menu until “Communication” is displayed > Press “Select” button
Scroll down menu until “Modems” is displayed and press “Select” button > “Primary” is
displayed > Press “Select” button
“Enable Modem” is displayed > Press “Select” button to set modem to be enabled
Scroll down menu until “Country Code” is displayed > Press “Select” button to set to UK
Scroll down menu until “Answer Mode” is displayed >Press “Select” button to set to numbered
rings of 1 ring
Scroll down menu until “Line Monitoring” is displayed > Press “Select” button to set mode to
“Disabled”
Press “Back” button until “Primary” is displayed > Scroll down menu until “Backup” is displayed
> Press “Select” button to disable the backup modem
Press the “Back” button until “Modems” is displayed > Scroll down menu until “Central Station”
is displayed > Press “Select” button
“Add” will be displayed > Press “Select” button to create a new “Central Station” account
Input account ID > Press “Enter” button. (Press and hold button for number input)
Input account name > Press “Enter” button > Select [SIA] as the protocol to use > Press “Select”
button
Input the 1st “Phone Number” > Press “Enter” button > Clear 2nd “Phone Number” and press
“Enter” button
Press ”Back” button until “Central Station” is displayed
Scroll down menu until “Remote Maint.” is displayed > Press “Select” button to enable “Remote
Maintenance”
Scroll down menu until “ID” is displayed > Press “Select” button > Input ID
Scroll down menu until “Password” is displayed > Press “Select” button > Input password
Scroll down menu until “In Conns. Setts” is displayed > Press “Select” button > Disable IP
Press back until “Remote Maint” is displayed > Scroll down menu until “SPC Pro” is displayed >
Press ”Select” button
Enable access, and input ID and passwords > Disable IP > Press “Back” until no longer in
“Engineer Mode”