Silhouette Infinity View Owner's manual

Infinity View
Technical
Instructions
Models 1594, 1595, 2922, 2923

Infinity View | Glazing with Silhouette Vision Sensation®
Lenses
Silhouette now offers premium prescription lenses
for all Silhouette frames.
Expertly crafted in Austria using our exclusive
Panorama®lens designs, Silhouette Vision Sensation®
lenses perfectly match the curve of every Silhouette
frame.
This results in a complete visual solution that offers
the wearer exceptional visual comfort and edge to
edge clarity.
For more information visit:
https://www.silhouette.com/us/us/vision-sensation
or contact your Silhouette Account Executive

Infinity View | Glazing
Frame is designed with a 5.0 base curve
Other base curves will work and should have
groove profile matching 5.0 base curve to
maintain frame curve
Recommended lenses are High Index 1.6,
1.67, Polycarbonate and Trivex
Patterns available from Silhouette customer
service at 800-223-0180
OMA shape files available at:
https://portal.silhouette.com
www.silhouettelab.com
Do not heat frame to aid lens insertion!
If lenses are large, resize to allow cold insert.
Do not clean Infinity View frames with alcohol!

Infinity View | Fullrim Groove Glazing
FULLRIM GROOVE GLAZING
0.6 mm
0.7 mm
Lenses must be cut on-size and groove must
follow size specification for proper lens
retention.
For best aesthetics, lens curve should match
the frame curve whenever possible to
maintain the frame curve.
Groove should be positioned so the front
surface of the prescription lens is flush with
the front surface of the frame.
Flatter lenses should have groove cut to
match a 5.0 base curve.
Groove depth: 0.6 mm | Groove width: 0.7 mm

Infinity View | Fullrim Groove Glazing Rubber Ring
Infinity View shapes require the use of
Silhouette Rubber Ring MH3 to prevent lens
rotation.
Lenses should not be cut large to prevent
rotation as this could stress the frame.
Do not heat frame to aid lens insertion!
Do not clean Infinity View frames with alcohol based liquids!

Infinity View end pieces are attached
to frame front using BLS sleeve.
In the event of end piece needing
replacement, use BLS 58 sleeve to
remount.
Compress using Silhouette mounting
plier and turquoise or blue tip.
Infinity View | End Piece Mounting

Infinity View | Lens Mounting
1. Insert lens from back side of frame
starting at the nasal corner.
2. Continue inserting lens along the
top to the temporal corner,
continuing around circumference
until lens snaps into place.

Infinity View | Lens Dismounting
Partially push frame off lens toward the back and remove lens
from front of frame.

Infinity View | Inclination
1. Open the temple.
2. Support BLS temple fixation
firmly with the mounting
pliers.
3. Hold end piece firmly and adjust
inclination into the required
position with fingers.

Infinity View | Temple Side Pressure Adjustment
Hold the BLS temple fixation with the mounting pliers and press the temple end piece
with your finger outward to open or inward with to close.