Silhouette SPX Illusion Nylor Owner's manual

SPX Illusion Nylor
Technical Instructions
126 March 2019

2
SPX Illusion Nylor —General Information
26 March 2019
Note groove width and depth Silhouette Nylor Mounting Tool
Part number: VGLH3
•easy to handle
•smooth surface
•thinner than other nylor tools
•1 end is tapered
•foldable material

3
SPX Illusion Nylor —General Information
26 March 2019
Part number: NY 2 –nylor thread Part number: AP 11 –nylor
thread fixation plate

4
Nylor Thread Exchange —SPX Illusion Nylor
26 March 2019
1. Use a lighter to melt a small ball
at the end of the nylor thread
2. Insert the nylor thread through
the nasal hole making sure the
melted ball fits in the frame
recess

5
Nylor Thread Exchange —SPX Illusion Nylor
26 March 2019
3. Insert the nylor thread through
one hole of the AP 11 fixation
plate and the lower frame hole
4. Insert the nylor thread from the
outside of the frame back
through the frame and the
fixation plate

6
Nylor Thread Exchange —SPX Illusion Nylor
26 March 2019
5. Verify that the fixation plate is
seated in frame recess
6. Size the nylor thread to hold
lens tight and trim excess

7
Nylor Thread Length Change —SPX Illusion Nylor
26 March 2019
1. Push nylor thread through lower temporal hole
2. The loop will increase and fixation plate may loosen
3. Adjust the length of nylor thread
4. Once length is determined, verify the fixation plate
is in recess of frame
5. Press excess thread through the upper hole
6. Trim the excess nylor thread if necessary

8
Inclination —SPX Illusion Nylor
26 March 2019
1. Open the temple
2. Support the frame at the hinge area with your thumb and index finger
3. Incline the temple at the hinge

9
Temple Disassembly —SPX Illusion Nylor
26 March 2019
1. Close temple and grab it with your
thumb and index finger
2. Using pressure on your index finger,
press the temple out of the frame

10
Temple Assembly —SPX Illusion Nylor
26 March 2019
Align the temple opening with the hinge and press it on hinge