Steelcase Kickplate Onto A 2” Panel Firmware update

Steelcase, Inc.
Grand Rapids, MI 49501
U.S.A.
1-888-783-3522
Tools
Assembly Directions Printed In U.S.A.
REV
93-9501070 A
Page 1 of 4
Kickplate Onto A 2” Panel
Package Contents
2
2
2
1
Screws
Panel kickplate retainers
Retainer clips
Kickplate

Assembly Directions
93-9501070 REV A Page 2 of 4
1. Lay kickplate on it’s back. Attach retainer clips into
open fold channels. Attach one clip on each end of
kickplate and one clip in the center of plate.
2. For panel assemblies 42” or wider place (2) kickplate retainers tightly along bottom edge of panel surface. If the
panel assembly is less than 42” in width, omit one retainer. Using the proper hole as a guide, drill (1) 1/8” dia. hole
into panel surface only. Secure kickplate retainers with (1) screw each.
RETAINER CLIP
RETAINER CLIP
PANEL SURFACE
PANEL KICKPLATE RETAINERS
CENTER OF PANEL
HOLE FOR
STANDARD PANEL
HOLE FOR
ACOUSTIC PANEL
SCREW

Assembly Directions
93-9501070 REV A Page 3 of 4
3. Press panel kickplate toward panel surface in direction
of arrow “A”. Slide panel kickplate down in direction of
arrow “B”, thus engaging top return flange over top edge
of kickplate retainer and engaging hooks into panel
upright.
4. After attaching completely into panel, bend retainer clips
towards the center of panel, with a flat tip screwdriver.
KICKPLATE RETAINERS
PANEL KICKPLATE
PANEL SURFACE
PANEL SURFACE
PANEL KICKPLATE
A
B
CLIP
SCREWDRIVER

Assembly Directions
93-9501070 REV A Page 4 of 4
NOTE: Because of differences in fabric thickness it may be necessary to open attaching hooks on panel
kickplates. If kickplate fails to fully engage into panel uprights, us a flat tip screwdriver to open kickplate
hooks by rotating screwdriver.