Unpacking
Thank you for purchasing the LED wall washer. Every LED wall washer has been well
tested and has been shipped in perfect operating condition. When receiving our
products carefully check the shipping carton for damage that might have happen during
transport. In case of damage inspect the fixture for any damage or missing accessories
necessary to operate. If parts are missing of fixture has been damaged please report this
to us.
Please do not take any action without first contacting us.
Introduction
The LED wash light is part of a wider range DMX intelligent LED wall washer. This
lighting is compact and lightweight and very easy to use. It is ideal for any rental job or
installation. The unit can be controlled by any DMX controller or in stand-alone mode.
Caution!
Do not attempt any repairs yourself! Doing so will void your manufactures warranty.
In the unlikely event your unit may require service please contact
Warning!
To prevent or reduce the risk of electrical shock or fire, do not expose this unit to rain
or any moisture.
Please read this user manual carefully to familiarize you with the basic operations of
this unit.
Safety Precautions
Do not expose this unit to rain or other moisture.
Before plugging to power be sure the local power outlet matches with the required
voltage of the unit
Do not remove the cover under any circumstances in case you’re not qualified to
do so.
Never connect to power when cover is removed.
Never use this unit if it becomes damaged.
Never connect this unit to any kind of dimmer and/or power pack.
If the unit will not be used for a long time, disconnect if from power supply.
Always mount this unit safe and stable, and make sure the area will have proper
ventilation. Take care this unit will not mounted in areas close to heat sources
such as lighting fixtures, amplifiers, heat registers, stoves and radiators.
Always contact us in case you have any doubts.
General Instructions
First familiarize yourself with the basic operation principals of this unit by reading the
attached user manual carefully. These instructions contain important safety information
regarding the use and maintenance of this unit.
Set up
Before plugging this unit to power make sure the voltage in your area matches the
required voltage for the LED wall washer. All these units are available in 90/260V
and 50/60Hz. Please always make sure this unit voltage matches your area
outlet voltage before attempting to operate the unit.
There are two ways to control your professional LED wall washer. The first
option is by ‘stand alone’ function, and probably the most used option by an
external controller via DMX. DMX is the standard language allowing
communication between controller and all kinds of DMX products from different
manufacturers. The order in which fixtures are connected in a DMX line does not
influence the DMX addressing. For example it does not matter if the last selected
address is in the beginning or in the middle of a DMX line; the controller always
will recognize the fixture by its address.
