Specialized Globe Haul ST Wheel Protector User manual

What’s included
A
D
C
E
B
# INCLUDED ITEMS QTY DESCRIPTION
A Upper cover 2 Installed on the rear fender rim
B Zip ties 4
C Wheel cover left 1 Large cutout (brake)
D Wheel cover right 1 Small cutout
E Tie straps 14
# REQUIRED ITEMS QTY DESCRIPTION
Scissors (not shown) 1 Trim the cable ties
Installing the finger guards may be easier with the
rear wheel removed. Read the rear wheel removal
and replacement section of the User Manual for more
information on how to safely remove the rear wheel.
The tie straps ends should be tightened toward the outside
of the frame. Failure to do so can make adjustment and
removal more difficult.
Assembly Instructions
The wheel covers are mounted to the rear of your Globe bicycle
using Velcro straps and the upper covers are clipped directly to
each side of the rear fender.
The following instructions guide you through assembling the upper
covers and wheel protectors securely to your bicycle.
A
D
D
C
B
Install the upper cover
zSlide the upper cover (A) behind the frame and clip the cover
onto the rear fender (B).
zThread two zip ties (C) through the mounting holes (D) and
secure the upper cover to the upper frame rail (E).
Install the wheel protector
AA
E
EE
A
F
B
D
C
zThread three tie straps (A) between the upper frame rail and the
upper wheel.
zSlide the tie strap through the buckle (B). The wheel cover should
hang loosely with approximately ¼ inch gap (C) between the
cover and the frame then fix the upper tie straps (D).
Do not over-tighten the top straps as this causes
difficulties tightening the lower and rear straps.
zAttach the three lower straps and fix them (E).
zAttach the rear strap and fix it (F).
zCheck that all seven straps are properly tightened and secured.
zRepeat the process for the other side.

Assembly Guide
Globe Haul ST Wheel Protector
CAUTION: Over tightening may cause premature wear or
tearing of the plastic cover.
The plastic buckles can rotate to provide a cleaner look.
The bottom front strap and buckle may cause heal
clearance issues when pedaling, make sure the buckle is
out of the way.
Safety Information
WARNING! The Globe rear wheel protector is intended for
use on Globe Haul Short Tail bicycles only.
WARNING! Before your first ride and regularly thereafter,
ensure the rear wheel protectors are securely tightened.
WARNING: The area where you ride may require specific
safety devices. It is your responsibility to familiarize
yourself with the laws of the area where you ride and
to comply with all applicable laws, including properly
equipping yourself, your passengers, and your bicycle as
the law requires.
WARNING! Riding with passenger on your bicycle affects
the handling by altering the center of gravity, weight, and
balance. It may also negatively impact your cornering
ability, increase your necessary stopping distance, and
reduce your ability to slow down and maneuver, especially
at higher speeds or down a steep grade. All of this can
result in a loss of control, potentially causing serious
injury and/or death. You should also become familiar with
and practice riding with the passenger in a controlled
environment away from traffic.
SPECIALIZED BICYCLE COMPONENTS
15130 Concord Circle, Morgan Hill, CA 95037 [phone]
0000192104_AG_R1 10/22
We may occasionally issue updates and addendums to this document. Please
periodically check www.globebikes.com or contact Rider Care to make sure you have the
latest information. Info: 877-808-8154
Online Video Guides
An informative and important video
explaining how to properly assemble
the Globe upper wheel cover and rear
wheel cover is available by scanning the
QR code. This assembly/setup guide is
intended to be used together with the
video.