Spectrum 55263 User manual

Media Director V2 Flip-Up Shelf
#55263
Assembly Instructions:
Tools Required:
Phillips Screwdriver
Adjustable Wrench
(4) 052605
1/4-20 x 15mm JC Bolt
Before you begin, please make sure all parts and proper quantities are
included. Any parts damaged during shipment must be reported within
5 days of receipt. To report information regarding damages or if you
have any questions, please call 1-800-235-1262.
A. Attach the (2) Folding Brackets to the Shelf Support with (6) 8-32 x 1/2" PHM Screws and Locknuts (3 per bracket) as shown in Figure 1.
Tighten securely.
Attach Folding Brackets to Shelf Support
1.
(6) 021587
8-32 x 1/2" PHMS
(6) 029019
8-32 Locknut
(1) 039622
2" Grommet
(8) 026073
#8 x 3/4" PHSM
Shelf Support
Folding Bracket
Figure 1
8-32 x 1/2" PHMS
(3 per Bracket)
8-32Locknut
0103308X Page 1 of 2

Note: If you are mounting the Flip-up Shelf to a lectern with a
Handle, the Shelf and Handle can be on the same side if
preferred, but the Shelf needs to be mounted in the middle or
lower position.
A. Determine the preferred side of the lectern to locate the shelf.
B. Attach the Shelf Support/Bracket Assembly to the Lectern using (4) 1/4-20 x 15mm JC Bolts. This assembly can be mounted at
several different heights depending on the application. Figure 2. (This Shelf is shown in the upper position.)
Attach Shelf Support/Bracket Assembly to the Lectern
2.
Shelf Support/Bracket
Assembly
1/4
20 15mm JC Bolts
Figure 2 2" Grommet
A. Attach the Shelf to the (2) Folding Brackets with (8) #8 x 3/4" PHSM Screws
(4 per bracket) as shown in Figure 3. Tighten securely.
B. Install the 2" Grommet.
Attach Shelf to Folding Brackets
3.
1/4
-
20
x
15mm
JC
Bolts
(4 Req'd)
Figure 3
Shelf
#8 x 3/4" PHSM Screws
(4 per Bracket)
Folding Bracket
0103308X Page 2 of 2