Spectrum 372 Series User manual

(4) 0103920
1/4-20 x 1/2”
Thumbscrew
037779
5/16-18 x 1” Glide
(20) 026064
1/4-20 x 5/8” PHMS
(1) 025069
Glide wrench
2 Glides / 2 Casters4 Glides 4 Casters
0101909
2-3/8” Caster
(with 5/16-18 stem)
(2) 037749
Unit-to-unit bracket
Unit-to-unit
bracket
(optional)
0106709R2 Page 1 of 2
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt. To
report information regarding missing parts or damage, to purchase parts or acces-
sories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Flex Training Tables
(24” and 30” deep)
372XX
Phillips
screwdriver
Tools
Required
Glide
wrench
Figure 1
Glides
Casters
Figure 1A
Attach legs with
1/4-20 x 5/8”
PHM screws
2 Glides /
2 Casters
4 Glides
4 Casters
1. Table Assembly
1. Place worksurface face-down onto a non-
abrasive surface.
2. Attach the legs to the worksurface using 1/4-20 x
5/8” PHM screws and tighten securely. Figure 1.
3. Attach the casters and / or glides to the legs.
Glides attach to the longer 28” tall legs, and
casters will attach to the shorter 27” tall legs.
Tighten securely with glide wrench.
4. If tables are to be connected together, attach the
unit-to-unit brackets as shown in Figure 1A.
5. Carefully ip the table upright-this may require
two people.
Rectangular Flex Training Tables come with glides
or casters in one of the following combinations:

Figure 2
0106709R2 Page 2 of 2
Worksurface #1
1/4-20 x 5/8” PHMS
(2 required)
Worksurface #2
Unit-to-unit
bracket
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
© 2016 Spectrum Industries Inc., All rights reserved.
1. If moving a table with the glide / caster combination, unlock the
casters and pick up the table from the glide-side and move.
2. Lock all casters after moving.
3. Moving Tables
2. Connecting tables together (optional)
1. Arrange the tables side-to-side in the preferred location.
2. Attach the unit-to-unit brackets to both table worksurfaces as shown
with 1/4-20 x 5/8” PHM screws and tighten securely. Figure 2.
Note: If a more temporary arrangement
is preferred, the easily removable 1/4-20
thumbscrews can be used on the unit-to-unit
brackets instead of Phillips screws.