Spectrum Evolution 38906 User manual

Assembly Instructions
Tools Required
052525R5 Page 1 of 2
Assembly Instructions
Important
Before you begin, read and comply with all safety and operating instructions,
and ensure all parts and correct quantities are included.
Any parts damaged during shipment must be reported within 5 days of receipt.
To report information regarding missing parts or damage, to purchase parts
or accessories, or if you have any questions, please contact us.
www.spectrumfurniture.com
800-235-1262, 715-723-6750
Thank you for purchasing Spectrum products!
Evolution Corner Connector (30”D)
38906
(2) 0102049
Z-bracket
(15) 026064
1/4-20 x 5/8” PHMS
(2) 050524
#8 x 3/4” PH TEK
screw
(2) 036281
Dual unit-to-unit
bracket
1. Attach Brackets & Cord Channel
1. Place the worksurface assembly face-down onto a non-abrasive surface.
2. Attach the two Flip-top support brackets and Cord Channel with
1/4-20 x 5/8” PHM screws as shown in Figure 1.
Figure 1
Worksurface
assembly
(1) 052510
Worksurface assembly
(1) 044234
Cord channel
Flip-top
support
brackets
Cord channel
(5) 1/4-20 x 5/8”
PHMS
(2) 041943
1/4-20 Locknut
(2) 021554
1/4-20 x 50mm
JC bolt
4mm Hex
wrench
(included)
Phillips
screwdriver
Drill with
Phillips
driver
or
(2) 036207
Flip-top support
bracket
(1) 025039
4mm Hex wrench

052525R5 Page 2 of 2
925 FIRST AVENUE, CHIPPEWA FALLS, WI 54729 / 800-235-1262 / 715-723-6750 / WWW.SPECTRUMFURNITURE.COM
© 2016 Spectrum Industries Inc., All rights reserved.
2. Attach Brackets to Desks
1. Attach the ‘Z’ Brackets to the rear of each desk as shown in Figure 2 using
(1) 1/4-20 x 50mm JC Bolt and Locknut. Tighten completely. Note: The
elongated hole on the ‘Z’ Bracket will attach to the Corner Connector.
2. Using an electric drill with a Phillips bit, install a #8 x 3/4” PH TEK Screw
through the ‘Z’ Bracket and into the leg. Be careful not to strip-out the screw.
3. Attach the Dual Unit-to-Unit Brackets to the front of each desk as shown. Do
not tighten completely.
3. Attach Corner Connector to Desks
1. Align both desks 90° to each other leaving about 6” between the corners as shown in Figure 3.
2. Place the Corner Connector onto the brackets and align the mounting holes.
3. Attach with (6) 1/4-20 x 5/8” PHM screws, but do not tighten completely-after the screws are
started, alignment of the desks may be necessary.
4. After alignment is satisfactory, tighten all screws.
1/4-20 x 50mm JC Bolt
#8 x 3/4” PH TEK screw
Figure 2
Corner connector
30”D Evolution desk
30”D Evolution desk
Figure 3
Flip section
open
1/4-20 Locknut
Leg
Z-bracket
(2) 1/4-20 x 5/8” PHMS
Front of desk
Cord channel
6
Dual
unit-to-unit
bracket