Sprout SOUS-CHEF Installation and operating manual

SOUS-CHEF
TODDLER TOWER
Make the World Accessible
ASSEMBLY & SAFETY GUIDE

F
Extra Step
E
Ladder
D
Platform
C
Back
B
Right Side
A
Left Side
LEFT RIGHT
H
Guard Plate
G
Dowel
Included Parts
Assembly Video
Assembly Video
Enjoy the best assembly experience
sprout-kids.com/TODT
SLOTS DIFFER
Please reach out to our support team if you need
any assistance along the way!
We’re Here to Help
Assembly Instructions
M-F 8-4 MST
[phone]
[email protected]

Place Left Side on carpeted floor with slots facing up.
Place tabs of Back C into corresponding slots and use
your weight to pop tabs into place. Then stand up the
parts and push down on Back C to lock into place.
A rubber mallet or a hammer used with a cuing board
can help align pieces.
1
Recommended
Begin Assembly
1
OR
Rubber Mallet
(not included)
Hammer with scrap wood
or cutting board (not included)
2Place Side B on carpet and insert Back C tabs into slots.
Stand up the assembly and push down on Back C to lock
into place. Back will be below-flush with Sides when
fully locked.
1
2
2
LOCKEDNOT LOCKED
3
B
B
C
C
C
C
C
A
A
A
C
C
C
3

Spread Sides just enough to insert Ladder E . Unless
Platform D is on lowest seing, also insert Extra Step F .
Push Sides together, catching tabs on Ladder E and Extra
Step F in slots on Sides. Ensure Ladder is flush (no gaps)
with Sides before moving on to the next step.
4
3
*
Spread sides apart to insert tabs on Platform D into slots
on Back C at desired height. Push sides together to
catch tabs on Platform D in slots on sides.
These are general recommendations. Observe how your child
uses their tower and adjust the height to meet their needs.
E
C
C
D
D
D
1
1
2
2
1
3
28”-32” Child*
32”-38” Child*
3
2
1
ENSURE LADDER IS
FLUSH WITH SIDES
E
D
D
E
F
F
F
38”-44” Child*
Front View

Please note that the Dowel is a vital safety feature for
this product. Your Toddler Tower should never be used
without the Dowel being securely locked into place.
5Doing one side at a time, slowly step on Ladder E to lock it
into place. Ladder should be almost flush with floor when
fully locked.
Insert Guard Plate H for children under 32” tall. Then
slide Dowel G into hole from side. Twist Dowel G while
pushing down to lock into place.
6
TWIST WHILE PUSHING
LOCKED
NOT LOCKED
E
E
G
G
G
H
H

Twist while pulling up on Dowel G to pop it out of place.
Slide Dowel G out of holes to remove. Flex Sides A & B
apart slightly to remove Guardplate H .
1
Turn the Tower upside down. Push down on the frame of
Ladder E to release it. Gently flex Sides apart to remove
Ladder E and Platform D .
2
With a book under each Side, place front legs of tower
against a wall. Doing one side at a time, push near the
middle of Back C with your knees while using your
weight to push Back down to unlock and release. Ensure
tabs are fully released before popping Sides o Back.
3
For Disassembly
AB
D
E
E
G
G
G
H
C
2
11
TWIST WHILE PULLING UP
H
E
D
AB

The Toddler Tower has been designed and refined to
maximize safety. Below are some safety tips and
recommendations you should consider:
Safety Information
Do not allow children to climb on the sides,
intentionally rock the tower, or climb up
through the top onto other surfaces.
As a general rule, if your child’s belly buon is
above the top of the tower’s sides, you should
lower the standing platform.
On the top seing for the smallest children,
we encourage you to use the guard plate
along with the dowel. The dowel should
always be locked in when the tower is in use.
The weight limit is 150 lbs.
Children should never use the tower without
adult supervision. This will enable you to step
in if your child is misusing the Toddler Tower.

2023 QUARK ENTERPRISES. LLC PO BOX 1123, PROVO, UT 84601 DOCUMENT: AI-TODT