Sprout WOVEWOOD DIVIDED TRAY User manual

WOVEWOOD DIVIDED TRAY
ASSEMBLY INSTRUCTIONS
Creating a Place for Everything

Ends (x2)
A
Divider
D
Boom
C
B
Sides (x2)
We’re Here to Help
Assembly Instructions
M-F 8-4 MST
[phone]
[email protected]
Included Parts
Please reach out to our support team if you need
any assistance along the way!
TAB
SLOT

Grab an End A and a Side B . Position the parts with
slots on the boom and Side relief towards the inside.
Insert lower two tabs into their appropriate slots on the
opposite piece.
1
Gently flex the parts to weave the top tab into its slot.
2
Repeat Steps 1and 2 for other End A and Side B .
3
Repeat Steps 1and 2 to weave the two sets of parts
together in the middle.
4
A
A
B
B
Begin Assembly
RELIEF ON
INSIDE
RELIEFS ON
INSIDE
SLOTS ON
BOTTOM
SLOTS ON
BOTTOM
A
A
B
B

Before weaving all the parts fully together, put Boom C
into place. Make sure the curved edges line up with both
Ends A as shown, and then wrap parts around Boom.
5
For last Side, catch boom tab in hole, and then weave
upward, as shown.
6
Place Divider D into tray diagonally and rotate into place.
7
A
D
C
2023 QUARK ENTERPRISES. LLC PO BOX 1123, PROVO, UT 84601 DOCUMENT: AI-WW10H
A
A
CURVED
EDGE