Sprout SOSTA BED 3 Rail User manual

2” Hex Screw
C
1.6” Hex Screw
B
PARTS
OPTIONAL
Power
Drill
INCLUDED TOOLS
Hex
Bit
4mm Hex
Wrench
3/4 Side Rail
A
3/4 Rail
SOSTA BED
ASSEMBLY GUIDE
(2x)
(2x)

Enjoy the best assembly experience
sprout-kids.com/3-4rail
ASSEMBLY VIDEO
1If using a drill, set clutch on drill to LOW SETTING (around 3).
If your drill has two speeds, set it to the SLOW SPEED (1).
A high clutch setting will strip screw heads and render parts useless!
CLUTCH TOO HIGH: If the drill twists dramatically in your hand when
drilling. Lower the clutch setting.
CLUTCH TOO LOW: If the screw does not screw in all the way. Adjust
clutch up by 1 setting and try again.
3
4
2
2
3
3
4
2
1
12
12
Align the holes of the 3/4 Side Rail with the holes in the
Headboard/Footboard and Platform.
2A
A

Partially screw (2x) 2” Hex Screws through the bottom holes of the
3/4 Side Rail and into the holes of the Platform.
Partially screw (2x) 1.6” Hex Screws through the side holes of the 3/4
Side Rail and into the side holes of the Headboard/Footboard.
A
3B
A
4C
1.6” Screw Actual Size
Place screw on paper to verify
correct size.
B
B
B
A
C2” Screw Actual Size
Place screw on paper to verify
correct size.
C
C
A

For Safety Regulations and Standards:
sprout-kids.com/sosta/safety
6
5Fully screw in each of the Hex Screws.
B
B
C
C
WWW.SPROUT-KIDS.COM
PO BOX 1123, PROVO, UT 84601
QUARK ENTERPRISES 2022
DOCUMENT: AI-SBT-3-4-Rail
If you have questions, reach out to [email protected]