Sprout SOSTA BED FULL RAIL User manual

PARTS
OPTIONAL
Power
Drill
INCLUDED TOOLS
Hex
Bit
4mm Hex
Wrench
Full Side Rail
A
2” Hex Screw
C
1.6” Hex Screw
B
FULL RAIL
SOSTA BED
ASSEMBLY GUIDE
(2x)
(4x)

Enjoy the best assembly experience
sprout-kids.com/fullrail
ASSEMBLY VIDEO
Align the holes of the Full Side Rail with the holes in the Headboard &
Footboard.
2A
1If using a drill, set clutch on drill to LOW SETTING (around 3).
If your drill has two speeds, set it to the SLOW SPEED (1).
A high clutch setting will strip screw heads and render parts useless!
CLUTCH TOO HIGH: If the drill twists dramatically in your hand when
drilling. Lower the clutch setting.
CLUTCH TOO LOW: If the screw does not screw in all the way. Adjust
clutch up by 1 setting and try again.
3
4
2
2
3
3
4
2
1
12
12
A
Holes on
bottom edge!

Partially screw (2x) 1.6” Hex Screws through the top holes of the Full
Side Rail and into the top holes of the Headboard and Footboard.
Partially screw (2x) 1.6” Hex Screws through the bottom holes of
the Full Side Rail and into the bottom holes of the Headboard and
Footboard.
A
B
3
4
B
A
B
B
A
B
B
A
1.6” Hex Screw Actual Size.
Place screw on paper to verify
correct size.
B

6Screw the (2x) 2” Hex Screws into the center holes of the Full
Side Rail .
5Fully screw in each of the (4x) 1.6” Hex Screws.
C
A
B
B
B
B
C
C
C
2” Hex Screw Actual Size
Place screw on paper to verify
correct size.
For Safety Regulations and Standards:
sprout-kids.com/sosta/safety
7
If you have questions, reach out to [email protected]
WWW.SPROUT-KIDS.COM
PO BOX 1123, PROVO, UT 84601
QUARK ENTERPRISES 2022
DOCUMENT: AI-SBT-Full-Rail