SSV Works TXF-OSP65 User manual

TXF-OSP65 - Teryx 4 Overhead Speaker Pod
Tools Needed For Installation
Drill with 1/4" and 1/8" Drill Bit
#2 Phillips Screwdriver
5/32 Allen Wrench
Wire Crimpers / Strippers
Installation Instructions:
Drill a hole through the enclosure for your speaker
wire to run out the side
Once the holes are drilled, run the speaker wire into the
enclosure and crimp on the terminals, be sure to have
enough length on the speaker wire to run to the location
where your amplifier will be mounted
You can now press the grill onto the speaker
Attach the speaker wires to the speaker be sure to
connect the speakers correctly identifying the + and -
speaker leads. Then screw the speaker into the enclosure

Pre-drill the small hole locations on the side of each metal
bracket with the 1/8" drill bit, then using the screws
provided secure the metal bracket to the cage
Once the speaker is mounted in the enclosure you can
mount the enclosure into the cage, hold the enclosure into
place and using the screws and washers provided attach
the metal bracket to the enclosure
CORPORATE: SSV WORKS, 5330 Derry Ave, Ste N Agoura Hills, CA 91301
WEB: www.SSVworks.com FAX: [phone]
Once the enclosure is mounted into position, you may
need to align the grill so the logo on the speaker is
straight