Starkey Wi Series Assembly instructions

®
QuickTIPS
SURFLINK REMOTE CONTROL: SETUP
PRODUCT AVAILABILITY: Z Series, 3 Series wireless, Xino wireless, Wi Series
ENABLING SURFLINK REMOTE CONTROL IN INSPIRE
1. Launch Inspire 2014.3 or higher.
2. Connect and detect hearing aids to the fitting computer via the
appropriate programming accessories. Refer to the Boots and
Cables Programming Guide available via Inspire Online for additional
information regarding connecting the hearing aids.
3. Select New Session on the Get Started Screen and select Start.
4. Select Accessories on the left navigation bar.
5. Select Remote Control under SurfLink Accessories.
6. Select the appropriate faceplate: Advanced, Intermediate, or Basic.
NOTE: Default is Advanced.
7. Enter the SurfLink Remote Address (located on the back of the
SurfLink Remote) under Remote Control Syncing.
8. Select Sync.
NOTE: The hearing aids and SurfLink Remote are now synced.
9. For Advanced Remote Control, select a Favorite Button Configuration
from the drop down menu. Options include:
»None
»Stop/Start Audio Stream (default)
»iQ Boost
»Jump to memory 4
»MultiFlex Tinnitus On/Off (only available for the Z Series microRIC
312)
10. If also using a SurfLink Media Device, refer to the SurfLink Media Setup
QuickTIP available via Inspire online for additional information.
Favorite Button
Enable SurfLink Remote Control
SurfLink Accessory Sync Code

CHANGING REMOTE CONTROL USER FACEPLATE
1. If desired, change the plastic remote cover via the User Interface
Removal Tool.
2. Remove the rubber remote control interface.
3. Replace with desired remote control interface.
4. Snap the plastic remote cover into place over the rubber interface.
User Faceplate Removal
Faceplate Options
SURFLINK REMOTE FACEPLATE OPTIONS
»Basic offers volume control and Home.
»Intermediate offers volume control, Memory, Mute and Home.
»Advanced (default) offers volume control, Memory, Mute, Home
and Favorite that can be programmed via the Wireless Accessories
screen.
NOTE: All options include two sliders. One is located at the top of
the remote; it is used to make binaural/monaural adjustments. The
second slider is located at the bottom of the remote and is used to
lock the remote control. When locked, no adjustments can be made.