Steelcase 9000 Panel Transaction Top Series Firmware update

Steelcase, Inc.
Grand Rapids, MI 49501
U.S.A.
1-888-783-3522
Tools
Assembly Directions Printed In U.S.A.
REV
93-9504058 B
Page 1 of 3
NOTE: When adding transaction tops top panels, attention must be given to strengthen and stabilize the complete
panel wall system for optimum rigidity.
Series 9000®Panel Transaction Top

Assembly Directions
93-9504058 REV BPage 2 of 3
TRANSACTION TOP
PANEL UPRIGHT
LEFT HAND BRACE
TOP CAP
WOOD SCREW
NO. 10 X 3/4"
Make sure ends of top cap are adjusted down firmly against the panel uprights. Next center the transaction
top onto top cap. Now install (1) left hand brace into panel upright slots and start (2) screws. Next install
remaining braces in the same manner leaving screws loose.
1.
NOTE: A total of 6 braces are used with 60" and 70" wide transaction tops, when installed on two panels.
RIGHT HAND BRACE

Assembly Directions
93-9504058 REV BPage 3 of 3
2. Loosen screw one-half turn and rotate top plate 90
°
into position. Then start the remaining (3) screws.
Position the next transaction top and braces onto adjacent panel assembly, using the same assembly
procedure for
After all tops have been assembled, alternately tighten all screws.assembled. the first top. A nominal 1/16" gap should be maintained between transaction tops after
3.
TOP PLATE
ROTATE TOP PLATE
90°INTO POSITION
TRANSACTION TOP
LOOSEN SCREW
1/2 TURN
RIGHT HAND BRACE
SECOND TRANSACTION TOP
FIRST TRANSACTION
TOP
WOOD SCREW
NO. 10 X 3/4"
LEFT HAND BRACE
TOP PLATE
WOOD SCREW
NO. 10 X 3/4"
1/16" GAP