Steelcase Turnstone Smoke User manual

Page 1 of 4
TS5YFMRS Rev E
Smoke™Rotating Panel Screen R
©2001 Steelcase Inc.
Grand Rapids, MI 49501 U.S.A.
Printed in U.S.A.
1/2"
Note: Please handle the screen frames and infills
with care while unpacking and assembly.
7/32" & 1/4" Hex
Rubber mallet

Page 2 of 4
TS5YFMRS Rev E
For Ribbed Privacy, Frosted Acrylic
and Perforated Infills

1. Place panel flat against the floor. Attach lock
 washer, flat washer, flange bearing and shoulder
 screw to one end of panel and attach flat washer,
 caster stem and caster on opposite side.
(1/4")
A
A
NOTE:
While tightening screws and caster stems
press in directions of arrows (A) to remove
any gap between rails. Tighten all bolts
completely to a torque of 200-230 in/lbs.
Label location
(if applicable)
A
A
NOTE:
When using acrylic infills, place foam strip in
channels of frame on all four sides. Ensure that
the foam does not extend beyond the end of
channels to interfere when assembling the frames.
(7/32")
(7/32")
2. Orient infill so that the burn label is in the
 lower right hand corner of the screen.
 Perforated steel infill will not have a label.

3. Attach the two side bars before attaching
 the top and bottom.

Page 3 of 4
TS5YFMRS Rev E
2
2
3
2
2
31
1
A
A
A
A
4
For Markerboard Infills

1. Place the markerboard, aluminum
 bar and perforated infill so it is
 laying flat against the floor. Push
 the markerboard into the top of the
 aluminum bar, and the perforated
 infill into the bottom of the
 aluminum bar.

2. Attach the two sidebars, before
 attaching the top and bottom bars.
3. Attach lock washer, flat washer,
 flange bearing and shoulder
 screw to one end of panel and
 attach flat washer, caster stem
 and caster on opposite side.
4. Snap the eraser tray onto the
 center aluminum bar.

NOTE:
While tightening screws and caster
stems press in directions of arrows
(A) to remove any gap between rails.
Tighten all bolts completely to a
torque of 200-230 in/lbs.
(7/32")
(7/32") (1/4")

Page 4 of 4
TS5YFMRS Rev E
5. Stand panel upright and carefully place flange bearing assembly
 into base assembly.

NOTE: Tighten all bolts completely to a torque of 200-230 in/lbs.