Steelcase 464 Leap User manual

Page 1 of 4
939504810 Rev A
464 Leap®WorkLounge Headrest Replacement
(Customer Service)
®
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2005 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
#3 Phillips

Page 2 of 4
939504810 Rev A
1. Remove nameplate by pulling
down (1a). Remove the two (2)
small screws from the back of
pivots (1b).
2. Grab the ribbon on either side
of the nameplate and push the
back forward with the soft pads of
the thumb. (This will unclip the top
section of the back).
1a 1b
2
NAME PLATE
RIBBON

Page 3 of 4
939504810 Rev A
3. Remove the three (3) headrest
attachment screws with a #3 phillips
screwdriver.
4. Push the backrest forward while
tipping the headrest rearward to
remove it.
3 4

Page 4 of 4
939504810 Rev A
5. Install the new headrest with the three (3) new
screws provided.
6. Snap the back shell sockets into the rear pivot
cups (6a) (by slapping the back cushion with the
palm of your hand (6b), so that the screw holes are
aimed at the floor).
7. Hold back in place and reinstall the two (2) small
pivot screws.

8. Reinstall nameplate per step 1.
6b
6a
REAR
PIVOT CUP
BACK SHELL
SOCKET
7