Steelcase 9000 Series Firmware update

Steelcase, Inc.
Grand Rapids, MI 49501
U.S.A.
1-888-783-3522
Tools
Assembly Directions Printed In U.S.A.
REV
93-9501133 A
Page 1 of 3
Assembly Directions For Series 9000®E.I.P. Printer Shelf
Full End Panel (Printer Unit)
Clear Access End Panel (Printer Unit)
CONTENTS
QUANTITY DESCRIPTION
1 Printer Shelf
4 #10 x 1/2” Phillips Hd. Screw

Assembly Directions
93-9501133 REV A Page 2 of 3
1. Removal of outer end panel
Remove access cap by pulling upward on the left end cap.
With your finger, move the exposed release tab disengag-
ing top of outer end panel. With the top of outer end panel
tilted outward, lift up removing the bottom tabs.
2. Remove (2) 5/16” Dia. knock-out slugs in the approximate
location. Align holes “E” in the shelf, with holes “F” in the
end panel. Inset #10 x 1/2” screw thru hole “F” into hole
“E”, then tighten. (2) screws are required for each end of
the printer shelf.
2-1/4”
9-11/16”
5-3/4”
SCREW
#10 x 1/2”
“F”
“E”
OUTER END PANEL
INNER END
PANEL
TAB
ACCESS CAP
RELEASE TAB
Full End Panel (Printer Unit)

Assembly Directions
93-9501133 REV A Page 3 of 3
3. To install onto a clear access end panel unit simply position
shelf to line up with holes “D” near the back and bottom of
end panels. Insert #10 x 1/2” screw thru hole “C” and into
holes “D” of end panel. There are two screws required for
each end of the shelf. Tighten all screws securely.
“D”
“C”
10 x 1/2” SCREW
Clear Access End Panel (Printer Unit)