Steelcase 939501723 Firmware update

Steelcase, Inc.
Grand Rapids, MI 49501
U.S.A.
1-800-227-2960
939501723 Rev. A
Page 1 of 4
Assembly Directions Printed in U.S.A.
Tools
Elective Elements - Wall Mounted Overhead Storage
LEDGER STRIP
LOWER MOUNTING BRACKET
UNIT WITH DOORS
OPEN UNIT

Page2of4
939501723 Rev. A Steelcase
1.
Lufkin
R
478086489
3m/10'
1.
!CAUTION
TO PREVENT PERSONAL INJURY, ENSURE THAT LEDGER STRIP AND
MOUNTING BRACKET ARE MOUNTED INTO AT LEAST TWO WALL STUDS.
Determine height from floor,
then use ledger strip to mark
holes on wall.
CONCRETE OR BLOCK WALL INSTALLATION
STEEL WALL INSTALLATION
DRYWALL OR PLASTERED WALLS
Plastic wall anchors are recommended (”Expandet” brand or equivalent) to
secure ledger to wall. These are not provided.
Punch and drill holes in wall. Secure ledger with #10 x 1-1/2” flat head screws
(not provided).
When mounting storage cabinets to hollow wall construction the following
conditions must be met:
- Drywall must be at least 5/8” thick and attached securely to studs with screws.
- Studs must be at least 2” x 4” for wood, and 20 ga. or thicker for metal.
- Studs must be 24” on center, maximum.
- Secure directly to wall by using 3/16” dia. “Toggler” brand (or equivalent) hollow
wall fasteners with flat head bolts as per manufacture’s recommendations.
These are not provided.
2.
Make certain
ledger is level
NOTE: When mounting to a stud wall, if mounting holes do not align with wall
stud positions, additional holes must be drilled in the ledger and mounting
brackets at the stud locations.

3.
4.
5.
Position lower mounting bracket with rail in bottom of unit.
Determine which holes are in alignment, then remove those
screws from rail. Use same screws to (temporarily) install
mounting bracket to rail.
Lower unit back down and remove mounting bracket from rail.
Using two people, set the unit onto the ledger strip. Use
mounting bracket to mark hole locations in the wall.
Page3of4
939501723 Rev. A Steelcase
RAIL ON UNIT

Page4of4
939501723 Rev. A Steelcase
6.
7.
8.
Install lower mounting bracket to wall.
Refer to step 2 for appropriate method for type of wall.
Set unit onto ledger strip and lower mounting bracket.
Secure unit to ledger strip with screws provided and to
lower mounting bracket with screws from rail (that were
removed in step 5).