Steelcase Series 9000 Pedestal User manual

Page 1 of 8
939504517 Rev C
®
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2003 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
Series 9000®Pedestal, Drawer and Suspension Reconfiguration

Page 2 of 8
939504517 Rev C
1.Pedestal Removal and Installation
Box or Personal Drawer Removal
Pull drawer out until it stops. Press in on lock catch
spring and at the same time pull out on drawer. As
drawer approaches the end of case channel, tip
head of drawer down and lift out. Remove bottom
drawer first and move upward
2.File Drawer Removal
IMPORTANT: When removing file drawers from
pedestal, the cradle assembly must be removed with
the drawer at the same time. Store drawer on the
front face to prevent grease damage on floor. To re-
install, file drawer must be seated into the cradle
assembly then re-installed into pedestal. This is
done to insure proper drawer alignment and ease of
operation. Installer should wipe any excess grease
from exterior of cradle prior to re-assembly.
1
2
Drawer Head
Lock Catch
(Each Side
Of Drawer)
Back Flange
Cradle
File Drawer Head

Page 3 of 8
939504517 Rev C
3.Re-install File Drawer
Place cradle suspension onto the case channel as
shown in circled view. Slide drawer in until it stops.
Raise up slightly on drawer head to allow drawer
stops to pass the cradle stops. As drawer is closed
the remaining distance a slight up and down motion
of the drawer head will help the drawer seat into
place.
4.Re-install Box or Personal Drawer
Place roller (box drawer) or glide (personal drawer)
on rear of drawer runner over roller or glide on case
channel. Now, push inward. The lock catch will snap
into place and the drawer will level out on the case
channels.
3
4
Case Channel
Cradle Suspension
Nylon Glide On Personal Drawer
Roller On Case Channel
Roller On Box Drawer
PERSONAL
DRAWER
BOX DRAWER

Page 4 of 8
939504517 Rev C
Removing and Relocation Drawer
Suspensions, Bumpers and Lock
Bar Stops
1. Remove file drawer cradle suspension after file
drawer has been removed. Refer to Page 2 of these
Directions. Pull the cradle all the way out until the
bumper makes contact with suspension. Next, lift up
on front of cradle. Pull the rest of the way out.
To re-install reverse this Step.
2. Remove case channel and cradle suspension
by removing (2) screws. Next, lift up and pull out
case channel or suspension. To re-install refer to
Pages 7 and 8 of these directions then reverse this
Step.
3. Remove bumpers by removing screws. Pull
bumper retainer and bumper from slots and relocate.
Replace screws and tighten.
4. Remove and relocate lock stop. Place a flat
bladed screwdriver into notch of lock stop and turn to
the right.
5. Review Pages 5 & 6 of these Directions to
determine where to relocate the lock stop on the lock
bar. Insert lock stop into lock bar and tap into place
with a small hammer until it snaps into place.
NOTE: If you have a one-piece lock bar, refer to
pages 5 & 6 for alternate pedestal configurations
lock bar will work in. If configuration requires a
different lock bar, it can be ordered through
customer service.
2
4
5
1
Bumper
Suspension (Ref.)
Bumper
Screw Case Channel
Cradle Suspension
Lock Stop
Lock Stop

Page 5 of 8
939504517 Rev C
Lock Stop Locations Into Lock Bars
Used In 18” High Pedestals and Cases
"A" Pedestals
"B" Pedestals
"C & E" Pedestals
"D & F" Pedestals
"G" Pedestals
Pers Pers Pers Pers Box

Page 6 of 8
939504517 Rev C
Lock Stop Locations Into Lock Bars
Used In 24” High Pedestals and Cases
"L" Pedestals
After 1-Nov-95
"M" Pedestals
"N" Pedestals
Before 1-Nov-95
"O" Pedestals
(25" & 30" Only)
Before 1-Nov-95
"N" Pedestals
After 1-Nov-95
"L" Pedestals
Before 1-Nov-95
"O" Pedestals
(25" & 30" Only)
After 1-Nov-95
"P" Pedestals
"Q" Pedestals
Before 1-Nov-95
"R" Pedestals
"S" Pedestals
"T" Pedestals
"Q" Pedestals
After 1-Nov-95

Page 7 of 8
939504517 Rev C
Suspension Location for Various Drawer
Arrangements into a 18" High Pedestal
"B" Pedestal
(1) Box
(1) 12" File
"D" Pedestal
(1) Pers
(1) 15" File
"F" Pedestal
(2) Pers
(1) 12" File
"E" Pedestal
(2) Pers
(2) Box
"G" Pedestal
(4) Pers
(1) Box
NOTE: The following figures indicate various drawer
combinations and the location of suspensions and bumpers.
"A" Pedestal
(3) Box
"C" Pedestal
(1) 12" File
(1) Box

Page 8 of 8
939504517 Rev C
Suspension Location for Various Drawer
Arrangements into a 24" High Pedestal
NOTE: The following figures indicate various drawer combinations
and the location of suspensions and bumpers.
"M" Pedestal
(4) Box
"O" Pedestal
25" & 30" Only
(1) Pers
(1) Box
(1) 15"File
"Q" Pedestal
(2) Pers
(1) Box
(1) 12"File
"S" Pedestal
(4) Pers
(1) 12"File
"P" Pedestal
(2) Pers
(3) Box
"R" Pedestal
25" & 30" Only
(3) Pers
(1) 15"File
"T" Pedestal
(4) Pers
(2) Box
"L" Pedestal
(2) 12" File
"N" Pedestal
(2) Box
(1) 12" File