Steelcase AMQ Currency Enhanced User manual

Currency® Enhanced - Adding a Top to a No-Top Option
on a Low Storage Cabinet or AMQ®Embank
Page 1 of 4
Doc # 158157 Rev B
2
3
4
®®
If you have a problem, question, or request,
call your local dealer, Steelcase Line 1 at
888.STEELCASE (888.783.3522) or AMQ
Customer Care (877.801.0370) for immediate
action by people who want to help you.

Page 2 of 4
Doc # 158157 Rev B
FLUSH FLUSH
FLUSH
1. Place low storage cabinet upside down on
the worksurface and align with back and sides
of the low storage cabinet. (Do not install at
this time)
1
®®

Page 3 of 4
Doc # 158157 Rev B
NOTE: Cabinet is shown without the bottom for clarity.
1-1/2"
(36.75mm)
1"
(25.4mm)
2. Mark the worksurface at the end of the
locking door. (2a) Remove the low storage
cabinet, then add the two (2) lines per the
dimensions shown (2b).
2b
2a
®®

Page 4 of 4
Doc # 158157 Rev B
3. Place the lock strike bracket flush with the lines
made in step 2b and mark the holes as shown (3a).
Remove the lock strike bracket and drill two (2)
3/32" dia. x 1/2" deep holes in the marked locations (3b).
Position lock strike bracket over drilled holes and attach
with two (2) #6-18 x 5/8" flat head wood screws (3c).
4. Place low storage cabinet upside down on the
worksurface and align with back and sides as
shown on step 1 (4a). Open doors and install
cabinet to worksurface with four (4) screws (4b).
4a
FLUSH
FLUSH
Drill 3/32" Dia
x 1/2" deep
3a
3b
3c
4b
4b
®®