Steelcase Workcentre Credenza Firmware update

Power Driver
with Phillips tip
Tools
Posi-Drive
Assembly of Workcentre Credenza
Workcentre Unit
Right Hand Corner Unit
Unit with Integrated Adjustable Top
Steelcase, Inc.
Grand Rapids, MI 49501
U.S.A.
1-888-783-3522
Y9501725
Assembly Directions Printed in U.S.A.
Rev. C

Page2of5
Y9501725 Rev. C
A Screw (2) Steel Dowels into holes in
each End Panel.
B Move End Panels so dowels are
engaged into holes in Modesty Panel.
C Insert Cam Locks with arrows pointing
in direction of dowels into holes.
D Secure End Panels to Modesty Panel
with a half turn of Cam Locks.
1.
2.
Carefully turn top over and install
(2) Steel Dowels in holes.
3.
Screw (4) Steel Dowels into holes
in the back side of Modesty Panel.
B
A
B
MODESTY PANEL
AC
HALF TURN
D
ARROW TO
SIDE
Minimum clearance
2” (51 mm)
between top of modesty
and top of end panel.

ARROWS
TO SIDE
ARROWS DOWN
(will be used in step 5)
Page3of5
Fit (2) Support Legs onto dowels
in back of Modesty Panel. Secure
with cam locks.
(10) screws
per bracket,
10-12 x 5/8”
pan head
Lower assembly onto top and
secure with cam locks, brackets
and screws.
Carefully turn assembled
unit over.
4.
5.
6.
Y9501725 Rev. C

Page4of5
NOTE: A 97" Workcentre
uses a one piece back panel.
A 113" unit (shown here) requires
a three piece back panel.
Attach (2) Angle Brackets to each panel
as shown.
1.
Outside ends of
end panels use
these sets of holes
Inside ends of
end panels use
these sets of holes
LEG
WORKCENTRE
END PANEL
END
BACK PANEL
CENTER
BACK PANEL
Install Back Panels as shown.
2.
(6) screws
per bracket,
#10 x 5/8"
pan head
INSTALLATION OF
OPTIONAL BACK PANEL
LH
LH
CENTER
CENTER
RH
RH
Y9501725 Rev. C

Underside of Top Surface
Page5of5
Using predrilled holes in top surface,
position keyboard track.
Secure with (8) screws.
1.
2.
INSTALLATION OF
ADJUSTABLE KEYBOARD SHELF
FOR INTEGRATED TOP
Y9501725 Rev. C
(8) screws
#10-9 x 7/8”
pan head