Steelcase Ellipse H Junction User manual

Page 1 of 3
939504516 Rev D
®
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2003 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
Ellipse®‘H’ Junction - American General
The 'H' style worksurface may be attached adjacent right or left of
your desk worksurface. A right handed configuration is shown
throughout this instruction. Left hand installation is typical.
3/8"
Left hand installation Right hand installation

Page 2 of 3
939504516 Rev D
1. Position 'H' top on non-abrasive
surface. Locate leg above desired
mounting side of worksurface and fasten
leg. Do not tighten screws. Remove
outer leg cover and attach exterior
gusset to leg, align gusset mounting
holes to worksurface and attach with
screws. Secure all screws from leg and
gusset to worksurface.
2. Slide interior gusset into powerbeam.
Align all holes on powerbeam & gusset
with worksurface. Attach with screws.
Attach interior gusset to inside of leg as
shown in 'VIEW A'.
OUTER LEG COVER
(REMOVE)
EXTERIOR
GUSSET
1
2
VIEW A
INTERIOR
GUSSET
POWERBEAM
A
A

Page 3 of 3
939504516 Rev D
3. Align modesty panel mounting
holes with powerbeam holes and
fasten together with silver colored
screws. Attach modesty panel
brackets with black screws as
shown.
NOTE: Brackets are different. Do not
tighten black screws at this time.
4. Attach top brackets and worksurface straps to adjacent
worksurface. Invert 'H' Style Worksurface and attach.
Secure modesty panel brackets (insert into leg and push
down) and secure all screws. This completes the 'H' Style
Top attachment.
3
4
BLACK
SCREW
MODESTY
PANEL
BRACKET
90°
BLACK
SCREW
MODESTY
PANEL
MODESTY
PANEL
BRACKET
ADJACENT
WORKSURFACE
STRAPS
'H' STYLE WORKSURFACE
TOP BRACKET