Steelcase Leap V2 User manual

Steelcase Leap V2 Assembly Instructions
Step 1) Carefully remove
all packing material from
the box and place
components on a flat
surface.
Part List:
- 5-Star Chair Base
- Pneumatic Cylinder
- (5) Hard Caster Wheels
- Seating Unit with Back
and AdjustableArms
- Seat Pan
- 2 Seat Glides (May be
attached to chair)
Step 2) Insert caster
wheels into holes located
on the bottom of the 5-star
base. Push
metal locking mechanism
firmly into holes to lock in
place. Set the base of the
chair on the floor with
caster wheels down.
Step 3) Place the larger end of the cylinder
into the hole located in the center of the 5-
star base. Note the location of the arrow
sticker on cylinder.
Step 4) Identify if your
cylinder has a Side/Lever
Activated or Top/Button
Activated cylinder. See our
images for reference.
Side/Lever Activated Top/Button Activated
PAGE 1

Steelcase Leap V2 Assembly Instructions
PAGE 2
Top/Button Activated: Line up the
shaft on the gas cylinder with the
receive hole on the chair assembly
and then press firmly into place.
Take a hex screw and adjust
clockwise (to tighten) or counter
clockwise (to losen) the set screw.
Step 5: Only Follow Steps for Your Particular Cylinder
Side/Lever Activated:
Make sure cylinder lever is aligned
and pointing directly at the straight
bar piece. You can see this through
the hole in the top of the mechanism
to guide you.
Step 7:
While depressing the seat pan adjuster
(pictured), slide the seat pan to the track
assembled on the chair frame. (DO NOT SLIDE
SEAT ON UNTIL YOU VERIFY GAS
CYLINDER IS WORKING PROPERLY.)
Step 8:
Enjoy your chair! If you have any
issues with assembly, please call
844.630.3375 or email
[e-mail].
Step 6:
Attach the seat glides (if
not already in place).
Each is clearly labeled
either R for right side or
L for left side. They only
fit one way.
Before After