Steelcase Elective Elements Adjustable-Height Underworksurface... User manual

Page 1 of 3
939500228 Rev F
Elective Elements - Adjustable-Height
Underworksurface Storage
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
© 2018 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
2
3
4
Two File Drawers
Two Box and One File Drawer
Two High Lateral Files
NOTICE
3
Steps for correct installation of
soft close drawers
1
2
1
2
3
Pull LH and RH suspensions to full extents
Find and disengage rear posts, LH and RH
Align drawer suspensions and install
1134607001
Soft close mechanism
can be damaged if this
step is skipped.
RH post is
shown here
in yellow

Page 2 of 3
939500228 Rev F
1. Unlock (1a) and remove drawers
from cabinet (1b).
2. Remove finished top by removing
(4) screws through sub-top and (2)
screws from each corner bracket,
then lift top out.
3. Loosen screws on straps.
4. Raise adjustable-height brackets to
desired height, then retighten screws.
5. Remove protective tape from
decorative covers at top of
adjustable-height brackets.
1a
3
ADJUSTABLE-HEIGHT BRACKETS
STRAP
2
CORNER SUPPORT BRACKETS
4
2
To remove drawers
push lever down on one
side, and up on the other.
1b

Page 3 of 3
939500228 Rev F
6. Move cabinet into position.
7. Secure worksurface to adjustable-height
brackets with (4) screws through each bracket.
8. Reinstall finished top onto cabinet.
9. Reinstall drawers into cabinet.
a) Push drawer rails back into pedestal.
b) Pull bearing cages into forward position.
c) Check to see if lock is functioning properly.
If not follow illustration to adjust.
10. Adjust leveling glides as needed.
Front and side edges
of worksurface must align
with drawer fronts.
6
NOTE: Push brackets tight against end panels
when installing screws into worksurface.
7
9b 9a
Use a 5/32" Allen Wrench
to adjustlocking mechanism.
Rotate camclockwise for
upward movement, counter-
clockwise to move down.
9c