Steelcase Montage Wood Selections Firmware update

Steelcase, Inc.
Grand Rapids, MI 49501
U.S.A.
1-888-783-3522
Y9501922
Assembly Directions Printed in U.S.A.
Tools
Montage Wood Selections
Rev.D
- Bullet Top Worksurfaces
- P-Top Worksurfaces
- Sock Top Worksurfaces
- Scoop Top Worksurfaces
BULLET TOP WORKSURFACE
(Refer to page 2)
P-TOP WORKSURFACE
(Refer to page 3)
SCOOP TOP WORKSURFACE
(Refer to page 4)
SOCK TOP WORKSURFACE
(Refer to page 4)
GAP
GAP
GAP
GAP
IMPORTANT: Be certain to maintain a
1/8" (3.2mm) gap between worksurfaces.

1.
1.
2.
2.
3.
4.
Page2of4
Steelcase
ATTACH COLUMN BASE TO WORKSURFACE
ATTACH WORKSURFACE TO PANEL USING END
SUPPORT BRACKET AND SHARED CANTILVER
Turn top over onto a
soft, clean surface.
Attach base assembly.
Break tab on corner
support bracket and
bend tab on cantilever
bracket as shown.
Attach bracket to cantilever
and insert support bracket.
Lower worksurface onto
supports and secure with
screws provided.
Height may be adjusted
by turning column.
Use predrilled holes
in underside of top
Y9501922 Rev.D
1.
1.
BEND TAB DOWN
BREAK TAB OFF

1.00"
(25 mm)
1.00"
(25 mm)
1 3/8"
(35 mm)
1.
2.
3.
Page3of4
Steelcase
TO ATTACH WORKSURFACE TO
ANOTHER WORKSURFACE AT 90
Locate brackets on underside
of worksurfaces as shown.
Secure brackets with
screws provided.
Height may be adjusted
by turning column.
BOTTOM VIEW
FLUSH MOUNT BRACKETS
Y9501922 Rev.D

Page4of4
Steelcase
ATTACH SOCK TOP OR SCOOP TOP WORKSURFACE TO PANEL
USING END SUPPORT BRACKET AND SHARED CANTILVER
1.
1.
BEND TAB DOWN
BREAK TAB OFF
1.
2.
3.
4.
Break
bend
tab on corner
support bracket and
tab on cantilever
bracket as shown.
Attach bracket to cantilever
and insert support bracket.
Lower worksurface onto
supports and secure with
screws provided.
Height may be adjusted
by turning column.
Y9501922 Rev.D