Steelcase Turnstone Smoke TS 710 User manual

Page 1 of 2
TS710 Rev C
TS 710
Smoke™- Leg Installation
R
©2001 Steelcase Inc.
Grand Rapids, MI 49501 U.S.A.
Printed in U.S.A.
Table Desk with Legs
(Caster shown, glide legs assembled in same manner)
Note: For those legs with casters, the two (2) locking
casters should be oriented at the front side of the
worksurface.
Table Desk with Legs
1. Unpack the parts and lay them
out on a carpeted surface to avoid
scratches. Make sure you have all
the items shown.
2. Lay the worksurface upside
down with the leg mounting
holes facing up.
Wood screws (32) Caster Stems (4)
Top
Legs (4) Casters (4)

Page 2 of 2
TS710 Rev C
Table Desk with Legs (continued)
5. Attach legs to the worksurface. Align the holes with
the pilot holes on the top. Place (8) screws into holes
and drive them tightly.
NOTE:
Position legs with the angle of the legs facing outwards
toward the corner.
4. Insert casters over stems.
3. Thread caster stems into legs
(best method is to use socket
with portable drive).