Steelcase 2 Series User manual

If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2020 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
®
Page 1 of 7
145932 Rev B
Removal and Installation of Chair Control Shroud
on Steelcase Series®2 Chair
Torx T-30

®
1b
1a
1. Pull seat depth lever out (1a) (Optional: Insert paperclip
wire as shown in 1b) and slide seat forward.
2. Push and hold two square black buttons near the rear of
the seat (2a) as you slide the seat forward and off (2b).
2b
2a
SQUARE BLACK
BUTTONS
Page 2 of 7
145932 Rev B

®
Page 3 of 7
145932 Rev B
4
BLACK TAB
5
6
3
BOOST KNOB IN
“BOOST” POSITION
3. Put boost knob in the “boost” position
(middle knob position).
4. Recline the back and locate small black
tab on beige camlock. Press black tab with
Prybar until it’s in the groove.
5. Allow back to rock back to upright position
while holding Prybar in place. Pry camlock up
by pushing Pry bar down toward the chair control.
6. Hold frame as it starts to move back
and release from the chair control.

®
Page 4 of 7
145932 Rev B
7. Remove two (2) screws on each arm.
8. Remove arms.
9. Unclip rear cover by rotating upwards
as shown, then pulling off of hinge cover.
8
8
7
7
9

®
Page 5 of 7
145932 Rev B
1. Pull the front of the shroud forward
and down to disengage front hooks (1a),
then push back to disengage rear hooks (1b).
Spread the back of the shroud and lift off (1c).
2. Spread the back of the new shroud and place
into position (2a). Line up the rear hooks and
pull forward to engage (2b). Lift the front of the
shroud and engage the front hooks (2c).
Replace Seat Shroud
1a
1b
1c
2a
2b
2c
2c
ARM BAR NOT SHOWN
FOR CLARITY
2b