Steelcase turnstone Jenny Coffee Table User manual

R
©2016 Steelcase Inc.
Grand Rapids, MI 49501 U.S.A.
Printed in U.S.A.
PHILLIPS DRIVE, EXTENSION
AND POWER DRIVER
(OPTIONAL)
Coffee Table
End Table
Jenny™Coffee and End Table Leg Assembly
Page 1 of 2
75105 Rev B
5/32” ALLEN WRENCH

R
1. Lay table upside down on a clean, scratch
resistant surface.
2. Orient wood or plastic block leg to underside
of table as shown.
3. Insert pin on bottom of block into mounting
hole 1 (see template). Insert supplied screw
into block leg and into mounting hole 2 (see
template). Tighten screw with screwdriver.
4. Install glide into block leg as shown and
thread glide completely into block.
5. Repeat steps 3 and 4 for remaining block
legs.
Page 2 of 2
75105 Rev B
MOUNTING HOLE TEMPLATE
3
1. Lay table upside down on a clean, scratch
resistant surface.
2 .Align aluminum leg, glide, or round wood leg
with mounting hole 1 (see template). Thread
glide or round wood leg completely into table
by hand or thread aluminum leg completely
into table using 5/32” allen wrench.
3. Repeat step 2 for remaining legs or glides.
4
Jenny Table Assembly: Block Legs
Jenny Table Assembly: Aluminum Legs, Glides,
and Round Wood Legs
2
1
ALUMINUM
LEG
GLIDE
(typical all corners)
ALLEN
WRENCH
WOOD
LEG