Steelcase Elective Elements Storage User manual

Elective Elements™Storage for Dual-Sided & Continuous Top
If you have a problem, question, or request, call
your local dealer, or Steelcase Line 1 at
888.STEELCASE (888.783.3522)
for immediate action by people who want to help you.
(Outside the U.S.A., Canada, Mexico, Puerto Rico,
and the U.S. Virgin Islands, call: 1.616.247.2500)
Or visit our website: www.steelcase.com
©2013 Steelcase Inc.
Grand Rapids, MI 49501
U.S.A.
Printed in U.S.A.
3mm and 5mm
HEX DRIVES
#2 PHILLIPS DRIVE
1/4"
HEX DRIVE
Page 1 of 4
939502153 Rev C
FrameOne™Bench End Counter Above Applications
17/64" DIA.

2
Above End Counter Bracket Assembly
1. Set cabinet on its top so that bottom slot faces
upward.
2. Orient two brackets as shown, relative to the
single slot, and fasten to the bottom of the cabinet
with four #10 x 5/8” screws each.
2
Bottom slot
1
BOTTOM OF CASE
Page 2 of 4
939502153 Rev C

5
3. If FrameOne desk has worksurfaces already installed, remove them.
4. Loosely attach clamping bracket to cantilever using bolt through the bent top flange.
Note that the bottom of the clamp bracket should grab the bottom edge of the triangular leg tube.
5. Slide cantilever over leg so that it captures the triangular desk frame tube.
7. Attach cantilever using two screws provided.
8. Tighten clamping bracket bolt until it securely grips the leg.
9. Repeat steps to attach other cantilever.
6
4
Cantilever
9
4
8
Page 3 of 4
939502153 Rev C
6. Use the two holes in the cantilever top plate as a template to drill two
.266ʺ (17/64ʺ) diameter holes into the top of the horizontal frame tube.
7

10. Adjust set screws on cantilevers (see Step 12) to be flush with the
bracket.
11. Set U-channel onto cantilevers (centered), open side up.
12. Set cabinet onto cantilevers and U-channel so that the cabinet
mounting bracket slots engage both cantilever I-shape plates, locking the
back down, and the U-channel falls into the slot in the cabinet bottom.
13. Adjust set screws in cantilevers to level the cabinet.
14. Install one #10 x 5/8” tapping screw in the side of each
cantilever to secure the cabinet to the cantilevers.
15. (Re-) install FrameOne tops.
13
U-channel
Set screw
11
12
14
Tapping screw
Slots to engage
I-shape plates
I-shape
plate
Page 4 of 4
939502153 Rev C