Sunjoy L-GZ076PST-1A-4 User manual

1
IMPORTANT:
Please read and follow all safety statements, warnings, assembly instructions, use &
care directions, before attempting to assemble
IMPORTANT:
1. When installing and assembling your gazebo, it is recommended that 4 or
more adults are involved.
2. Do not use the unit during an electrical storm, as there is a remote chance of
getting struck by lightning.
3. Do not climb on top of the gazebo. Falling off the gazebo can result in
serious injury, possibly even death.
4. Do not leave the gazebo assembled when there is a risk of high wind, as
possible damage will occur to the structure.
5. Never barbecue under this gazebo or use lanterns that contain open flames.
6. This package contains small items and plastic bags that should be kept
away from children.
7. Ensure that all connectors & poles are firmly secured fully in position. It is
important to do so before use so as to avoid collapsing or damage to the
item, which could result in injury.
L
Assembly Instructions
ITEM#:L-GZ076PST-1A-4
Vineyard Gazebo

2
AA M5×15 mm Screw 56 PCS
BB M5 Flat Washer 56 PCS
CC M6 Nut 6 PCS
DD M6×30 mm Screw 8 PCS
EE M6 Flat washer 14 PCS
FF Plastic Washer 4 PCS
WStake 8PCS
GG Plastic Tie 48 PCS
HH M5×45 mm Screw 8 PCS
WW M6 Wrench 1 PC
Hardware Pack
Spare Hardware
AA M5×15 mm Screw 4 PCS
BB M5 Flat Washer 4 PCS
CC M6 Nut 6 PCS
DD M6×30 mm Screw 2 PCS
EE M6 Flat Washer 2 PCS
GG Plastic Tie 4 PCS
HH M5×45 mm Screw 2 PCS

3
Pole 1 A1 2
Pole 2 A2 1
Pole 3 A3 1
Pole 4 A4 1
Pole 5 A5 1
Fence B 4
Screen C 6
Corner connector D 6
Top pole E 6
Center fitting with hook F 1
Glass side bar top G 1
Side bar top support
(preassembled on the side bar top
G)
H2
Peg fitting 1 I 2
Peg fitting 2 J 2
Peg fitting 3 K 2
Canopy S 1
Top canopy S1 1
Bug netting S2 1
Parts List
Parts List

4
Step.1: Insert Fence (B) into Pole (A4 or A2), then fix (B) by pulling it down (Fig.1A).
Assemble Fence (B) and pole with.Screw (HH) and Flat washer (BB) (Fig.1B).
Step.2: Use Screw (AA) and Flat washer (BB) to
connect Peg fitting (K) to Fence (B) and Pole (A4 or
A2) (Fig.2). Assemble Peg fitting (J) to Fence (B) and
Pole (A1) in the same way.
Step.3: Use Screw (AA) and Flat washer (BB)
to assemble Peg Fitting (I) and Fence (B) and
Pole (A3 or A5) (Fig.3).
++

5
*After steps above, use screwdriver and wrench to tighten all the hardware, but not too tight.
Step.6: Assemble the canopy (S) on top
frame (do not tighten) (Fig6-1). Fully
assemble top canopy (S1) on small top
frame, (Fig.6-2). Tie the bug netting
around the top canopy to canopy and
then fully stretch canopy (S) and fix it to
the end of corner connectors (D) (Fig 6-3)
Step.4: Use Screw (AA) and Flat washer
(BB) to fix the Corner connector (D) to the
poles (Fig4-1). Use Screw (AA) and Flat
washer (BB) to assemble the Screen (C) and
pole (Fig4-2).
Use Screw (AA) and Flat washer (BB) to fix
the Corner connector (D) and the Screen (C)
(Fig4-3)
Fig.5-2 E
D
Step.5: Use Screw (DD), Flat washer
(EE) and Nut (CC) to joint Top pole
(E) and Center connector (F) (Fig
5-1). And then lift the assembled top
frame to insert the other end of the
Top pole (E) into the Corner
connector (D) (Fig.5-2)
)LJ


S1
S
)LJ


)LJ


Fig.5-1

6
USE & CARE:
1. This Gazebo is not a permanent structure and should be disassembled & stored away after use.
2. Do not repack your gazebo until completely dry.
3. This Gazebo must be assembled by Four adults or more.
4. This Gazebo must not be left erect in windy conditions.
5. Loading limit of the hook is 45 lbs
6. Loading limit of the ring is 25 lbs
7. Loading limit of the glass side bar top is 33 lbs.
Step. 7: Use Screw (DD), Flat washer (EE) and Plastic
washer (FF) to fix the Glass side bar top (G) to Pole (A3
and A4) and then use Wrench (WW) to tighten the
screw, but not too tight so that the glass bar top can flip
smoothly. Insert the pin on the pole into the hole at the
end of the bar top support (H) and then put the dowel
attached to the little chain into the pin on the pole to set
up the side bar top (Fig 7). When not in use, the side bar
top support (H) can go separately with the poles and the
top can stand vertically.
)LJ




)LJ




Step 8
˖
Use stake (W) to fix the gazebo on ground (Fig.
8-1). Lastly use the Plastic ties (GG) to fix the Bug netting
(S2) to the screen (Fig. 8-2), and tie the bug netting to the
poles.
Now the gazebo is ready for use.

7
WARNINGS:
1. Assembly Instructions must be followed.
2. Pegs supplied must be used to hold this gazebo in place when upright.
3. Warranty does not cover damage due to extreme weather conditions.
4. Do not use candles, matches or open flames of any kind in or near a tent.
5. Do not cook inside the tent.
6. Build campfires downwind and several meters away from a tent and be sure to fully
extinguish campfires before leaving a campsite or before retiring for the night.
7. Exercise extreme caution when using fuel-powered lanterns or heaters inside a tent and use
battery-operated lanterns whenever possible.
8. Do not refuel lamps, heaters or stoves inside a tent.
9. Extinguish or turn off all lanterns before going to sleep.
10.Do not smoke in a tent.
11.Do not store flammable liquids inside a tent
12. KEEP ALL FLAME AND HEAT SOURCES AWAY FROM THIS TENT FABRIC. This tent is
made of flame-resistant fabric. It is not fireproof. The fabric will burn if left in continuous contact
with a flame source.