Sunricher SR-2812 User manual

SR-2812 User Manual
1.Button introduction
short press: switch on/off of lighting
long press:press zone button ( 1 or
2 or 3 or 4), then do long press on
"ON/OFF" button , which is to dim
brightness of any zone
short press: starting mode or pause
mode, there are 10 bulid-in modes
long press: press zone button ( 1 or 2
or 3 or 4), then do long press on button
which is to adjust speed.

2.Wiring
Please do connection as below picture
SR-2812 Back
Each zone will get 4 addresses. Such as button one is address from 1-4, then button 2 is 5-8. Button 3 is 9-12, button 4 is 13-
16.There are total 16 address.
Zone 1 address is from 1 - 4. Address .Zone 2 address is from 5 - 8.
Zone 3 address is from 9 - 12.Zone 4 address is from 13 - 16.
Take zone 1 as an example, address 1 indicates the channel of “R” (red); address 2 indicates the channel of “G” (green);
address 3 indicates the channel of “B” (blue); address 4 indicates the channel of “W” (white / yellow / any color). So do the
address from zone 2,3,4(address:5-8, 9-12,13-16).
We control DMX controllers of each zone by different DMX address.
Note: the address of zone 1 is fixed from 1-4; the address of zone 2 is fixed from 5-8; the address of zone 3 is fixed
from 9-12; the address of zone 4 is fixed from 13-16.So we only can change the address of DMX decoder ,then
corresponding zone can control DMX decoder separately or synchronously.
3.Operation
a.how to operate zone button
b.how to save color or mode
Button can save the color from mode or save color when you touch color wheel.
In "S" button, it saved "R/ G/ B" 3 colors in default. But with your operation, you can save another 3 colors replace those
R/G/B colors.
Press any zone button----> press button, mode runs, see favorite mode---> press”S button over 3 seconds until
connected light flashes. Then it saved successfully.
Press any zone button----> touch color wheel, see favorite color---> press”S button over 3 seconds until connected
light flashes. Then it saved successfully.